STM32F038E6P7 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F038E6P7

ARM®-based 32-bit MCU with 32 Kbyte Flash, 9 timers, ADC and communication interfaces, 1.8 V

STMicroelectronics 

STM32F038x6

Electrical characteristics

6.2

Absolute maximum ratings

Stresses above the absolute maximum ratings listed in Table 15: Voltage characteristics,

Table 16: Current characteristics and Table 17: Thermal characteristics may cause

permanent damage to the device. These are stress ratings only and functional operation of

the device at these conditions is not implied. Exposure to maximum rating conditions for

extended periods may affect device reliability.

Table 15. Voltage characteristics(1)

Symbol

Ratings

Min

Max

Unit

VDD–VSS

VDDA–VSS

VDD–VDDA

VBAT–VSS

VIN(2)

External main supply voltage

External analog supply voltage

Allowed voltage difference for VDD > VDDA

External backup supply voltage

Input voltage on FT and FTf pins

Input voltage on POR pins

Input voltage on TTa pins

BOOT0

− 0.3

- 0.3

-

- 0.3

VSS −0.3

VSS −0.3

VSS −0.3

0

1.95

V

4.0

V

0.4

V

4.0

V

VDDIOx + 4.0 (3) V

4.0

V

4.0

V

9.0

V

Input voltage on any other pin

|∆VDDx|

|VSSx - VSS|

Variations between different VDD power pins

Variations between all the different ground

pins

VSS −0.3

-

-

4.0

V

50

mV

50

mV

VESD(HBM)

Electrostatic discharge voltage

(human body model)

see Section 6.3.11: Electrical

sensitivity characteristics

-

1. sAullpmplayi,ninpothweepr e(VrmDiDtt,eVdDrDaAn)gaen. d ground (VSS, VSSA) pins must always be connected to the external power

2. ValIlNowmeadxiimnjeucmtemducsutrraelwntavyaslubeesr.espected. Refer to Table 16: Current characteristicsfor the maximum

3. Valid only if the internal pull-up/pull-down resistors are disabled. If internal pull-up or pull-down resistor is

enabled, the maximum limit is 4 V.

DocID026079 Rev 5

39/102

79

Share Link: