TDA7402_00 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

TDA7402_00

CAR RADIO SIGNAL PROCESSOR

STMicroelectronics 

Figure 26. Signals during stereodecoder’s SoftMute

TDA7402

Figure 27. Signal-Control via SoftMute-Pin

3.2 InGain + Infilter

The InGain stage allows to adjust the MPX-signal to a magnitude of about 1Vrms internally which is the recom-

mended value. The 4.th order input filter has a corner frequency of 80kHz and is used to attenuate spikes and

noise and acts as an anti-aliasing filter for the following switch capacitor filters.

3.3 Demodulator

In the demodulator block the left and the right channel are separated from the MPX-signal. In this stage also the

19-kHz pilottone is cancelled. For reaching a high channel separation the A619 offers an I2C-bus programmable

roll-off adjustment which is able to compensate the lowpass behavior of the tuner section. If the tuner’s attenu-

ation at 38kHz is in a range from 7.2% to 31.0% the A619 needs no external network in front of the MPX-pin.

Within this range an adjustment to obtain at least 40dB channel separation is possible. The bits for this adjust-

ment are located together with the fieldstrength adjustment in one byte. This gives the possibility to perform an

33/59

Share Link: