PIC32MX210F016C-I View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC32MX210F016C-I

32-bit Microcontrollers (up to 128 KB Flash and 32 KB SRAM) with Audio and Graphics Interfaces, USB, and Advanced Analog

Microchip Technology 

PIC32MX1XX/2XX

TABLE 29-8: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS

DC CHARACTERISTICS

Standard Operating Conditions: 2.3V to 3.6V (unless otherwise

stated)

Operating temperature -40°C ≤ TA ≤ +85°C for Industrial

-40°C ≤ TA ≤ +105°C for V-temp

Param.

No.

Symbol

Characteristics

Min.

Typical(1) Max. Units

Conditions

VIL

Input Low Voltage

DI10

I/O Pins with PMP

VSS

— 0.15 VDD V

I/O Pins

VSS

—

0.2 VDD V

DI18

SDAx, SCLx

VSS

—

0.3 VDD V SMBus disabled

(Note 4)

DI19

SDAx, SCLx

VSS

—

0.8

V SMBus enabled

(Note 4)

VIH

DI20

Input High Voltage

I/O Pins not 5V-tolerant(5)

0.65 VDD

—

VDD

V (Note 4)

I/O Pins 5V-tolerant with 0.25 VDD + 0.8V —

PMP(5)

I/O Pins 5V-tolerant(5)

0.65 VDD

—

5.5

V (Note 4)

5.5

V

DI28

SDAx, SCLx

0.65 VDD

—

5.5

V SMBus disabled

(Note 4)

DI29

SDAx, SCLx

2.1

—

5.5

V SMBus enabled,

2.3V ≤ VPIN ≤ 5.5

(Note 4)

DI30 ICNPU Change Notification

Pull-up Current

50

250

400

μA VDD = 3.3V, VPIN = VSS

DI31

ICNPD

Change Notification

Pull-down Current(4)

—

50

—

µA VDD = 3.3V, VPIN = VDD

IIL

Input Leakage Current

(Note 3)

DI50

I/O Ports

—

—

+1

μA VSS ≤ VPIN ≤ VDD,

Pin at high-impedance

DI51

Analog Input Pins

—

—

+1

μA VSS ≤ VPIN ≤ VDD,

Pin at high-impedance

DI55

MCLR(2)

—

—

+1

μA VSS ≤ VPIN ≤ VDD

DI56

OSC1

—

—

+1

μA VSS ≤ VPIN ≤ VDD,

XT and HS modes

Note 1: Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only

and are not tested.

2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified

levels represent normal operating conditions. Higher leakage current may be measured at different input

voltages.

3: Negative current is defined as current sourced by the pin.

4: This parameter is characterized, but not tested in manufacturing.

5: See the “Pin Diagrams” section for the 5V-tolerant pins.

DS61168C-page 250

Preliminary

© 2011 Microchip Technology Inc.

Share Link: