R5F21122DFP-U0 View Datasheet(PDF) - Renesas Electronics

Part Name

Description

Manufacturer

R5F21122DFP-U0

RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / R8C /Tiny SERIES

Renesas Electronics 

R8C/12 Group

17.4 CPU Rewrite Mode

17.4.1 EW0 Mode

The microcomputer is placed in CPU rewrite mode by setting the FMR01 bit in the FMR0 register to “1”

(CPU rewrite mode enabled), ready to accept commands. In this case, because the FMR1 register's

FMR11 bit = 0, EW0 mode is selected.

Use software commands to control program and erase operations. Read the FMR0 register or status

register to check the status of program or erase operation at completion.

When moving to an erase-suspend during auto-erase, set the FMR40 bit to “1” (erase-suspend en-

abled) and the FMR41 bit to “1” (erase-suspend requested). Make sure that the FMR46 bit is set to “1”

(enables reading) before accessing the user ROM space. The auto-erase operation resumes by set-

ting the FMR41 bit to “0” (erase restart).

17.4.2 EW1 Mode

EW1 mode is selected by setting FMR11 bit to “1” (EW1 mode) after setting the FMR01 bit to “1” (CPU

rewrite mode enabled).

Read the FMR0 register to check the status of program or erase operation at completion. Avoid ex-

ecuting software commands of Read Status register in EW1 mode.

To enable the erase-suspend function, the Block Erase command should be executed after setting the

FMR40 bit to “1” (erase-suspend enabled). An interrupt to request an erase-suspend must be in en-

abled state. After passing td(SR-ES) since the block erase command is executed, an interrupt request

can be acknowledged.

The FMR41 bit is automatically set to “1” (erase-suspend requested) if the auto-erase operation is

halted by an interrupt request. If the erase operation is not completed (FMR00 bit is “0”) when the

interrupt routine is ended, the Block Erase command should be executed again by setting the FMR41

bit to “0” (erase restart).

Rev.1.20 Jan 27, 2006 page 145 of 181

REJ09B0110-0120

Share Link: