STM32F103VC Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

STM32F103VC

Medium-density performance line ARM-based 32-bit MCU with 64 or 128 KB Flash, USB, CAN, 7 timers, 2 ADCs, 9 com. interfaces

STMicroelectronics 

STM32F103xC, STM32F103xD, STM32F103xE

Electrical characteristics

5.2

Absolute maximum ratings

Stresses above the absolute maximum ratings listed in Table 7: Voltage characteristics,

Table 8: Current characteristics, and Table 9: Thermal characteristics may cause permanent

damage to the device. These are stress ratings only and functional operation of the device

at these conditions is not implied. Exposure to maximum rating conditions for extended

periods may affect device reliability.

Table 7. Voltage characteristics

Symbol

Ratings

Min

Max

Unit

VDD–VSS

External main supply voltage (including VDDA

and VDD)(1)

–0.3

4.0

Input voltage on five volt tolerant pin(2)

VIN

Input voltage on any other pin(2)

VSS  0.3

+5.5

V

VSS 0.3

VDD+0.3

|VDDx| Variations between different VDD power pins

|VSSX VSS| Variations between all the different ground pins

50

mV

50

VESD(HBM)

Electrostatic discharge voltage (human body

model)

see Section 5.3.12:

Absolute maximum ratings

(electrical sensitivity)

1. All main power (VDD, VDDA) and ground (VSS, VSSA) pins must always be connected to the external power

supply, in the permitted range.

2. IINJ(PIN) must never be exceeded (see Table 8: Current characteristics). This is implicitly insured if VIN

maximum is respected. If VIN maximum cannot be respected, the injection current must be limited

externally to the IINJ(PIN) value. A positive injection is induced by VIN > VINmax while a negative injection is

induced by VIN < VSS.

Table 8. Current characteristics

Symbol

Ratings

Max.

Unit

IVDD

Total current into VDD/VDDA power lines (source)(1)

150

IVSS

Total current out of VSS ground lines (sink)(1)

150

Output current sunk by any I/O and control pin

IIO

Output current source by any I/Os and control pin

Injected current on NRST pin

25

 25

mA

±5

IINJ(PIN) (2)(3) Injected current on HSE OSC_IN and LSE OSC_IN pins

±5

Injected current on any other pin(4)

±5

IINJ(PIN)(2) Total injected current (sum of all I/O and control pins)(4)

± 25

1. All main power (VDD, VDDA) and ground (VSS, VSSA) pins must always be connected to the external power

supply, in the permitted range.

2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN > VDD while a negative injection is induced by VIN < VSS.

3. Negative injection disturbs the analog performance of the device. See note in Section 5.3.18: 12-bit ADC

characteristics.

4. When several inputs are submitted to a current injection, the maximum IINJ(PIN) is the absolute sum of the

positive and negative injected currents (instantaneous values). These results are based on

characterization with IINJ(PIN) maximum current injection on four I/O port pins of the device.

Doc ID 14611 Rev 7

41/123

Share Link: