STM32F103VC データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

STM32F103VC

Medium-density performance line ARM-based 32-bit MCU with 64 or 128 KB Flash, USB, CAN, 7 timers, 2 ADCs, 9 com. interfaces

STMicroelectronics 

STM32F103xC, STM32F103xD, STM32F103xE

Description

2.3.17

periodic interrupt. It is clocked by a 32.768 kHz external crystal, resonator or oscillator, the

internal low power RC oscillator or the high-speed external clock divided by 128. The

internal low-speed RC has a typical frequency of 40 kHz. The RTC can be calibrated using

an external 512 Hz output to compensate for any natural quartz deviation. The RTC features

a 32-bit programmable counter for long term measurement using the Compare register to

generate an alarm. A 20-bit prescaler is used for the time base clock and is by default

configured to generate a time base of 1 second from a clock at 32.768 kHz.

Timers and watchdogs

The high-density STM32F103xx performance line devices include up to two advanced-

control timers, up to four general-purpose timers, two basic timers, two watchdog timers and

a SysTick timer.

Table 4 compares the features of the advanced-control, general-purpose and basic timers.

Table 4. High-density timer feature comparison

Timer

Counter

resolution

Counter

type

Prescaler

factor

DMA request Capture/compare Complementary

generation

channels

outputs

TIM1,

TIM8

16-bit

Up, Any integer

down, between 1

up/down and 65536

Yes

4

Yes

TIM2,

TIM3,

TIM4,

TIM5

16-bit

Up, Any integer

down, between 1

up/down and 65536

Yes

4

No

TIM6,

TIM7

16-bit

Any integer

Up between 1

Yes

and 65536

0

No

Advanced-control timers (TIM1 and TIM8)

The two advanced-control timers (TIM1 and TIM8) can each be seen as a three-phase

PWM multiplexed on 6 channels. They have complementary PWM outputs with

programmable inserted dead-times. They can also be seen as a complete general-purpose

timer. The 4 independent channels can be used for:

● Input capture

● Output compare

● PWM generation (edge or center-aligned modes)

● One-pulse mode output

If configured as a standard 16-bit timer, it has the same features as the TIMx timer. If

configured as the 16-bit PWM generator, it has full modulation capability (0-100%).

In debug mode, the advanced-control timer counter can be frozen and the PWM outputs

disabled to turn off any power switch driven by these outputs.

Many features are shared with those of the general-purpose TIM timers which have the

same architecture. The advanced-control timer can therefore work together with the TIM

timers via the Timer Link feature for synchronization or event chaining.

Doc ID 14611 Rev 7

19/123

Share Link: