CS8420-CSR データシートの表示（PDF） - Cirrus Logic

部品番号

コンポーネント説明

メーカー

CS8420-CSR

Digital Audio Sample Rate Converter

Cirrus Logic 

CS8420

16.2.2 Capacitor Selection

The type of capacitors used for the PLL filter can have a significant effect on receiver performance. Large

or exotic film capacitors are not necessary as their leads and the required longer circuit board traces add

undesirable inductance to the circuit. Surface mount ceramic capacitors are a good choice because their

own inductance is low, and they can be mounted close to the FILT pin to minimize trace inductance. For

CRIP, a C0G or NPO dielectric is recommended, and for CFILT, an X7R dielectric is preferred. Avoid ca-

pacitors with large temperature coefficients, or capacitors with high dielectric constants, that are sensitive

to shock and vibration. These include the Z5U and Y5V dielectrics.

16.2.3 Circuit Board Layout

Board layout and capacitor choice affect each other and determine the performance of the PLL. Figure

42 contains a suggested layout for the PLL filter components and for bypassing the analog supply voltage.

The 0.1 µF bypass capacitor is in a 1206 form factor. RFILT and the other three capacitors are in an 0805

form factor. The traces are on the top surface of the board with the IC so that there is no via inductance.

The traces themselves are short to minimize the inductance in the filter path. The VA+ and AGND traces

extend back to their origin and are shown only in truncated form in the drawing.

1000

pF

Crip

.1µF

Cfilt

Figure 42. Recommended Layout Example

16.3 Component Value Selection

When transitioning from one revision of the part another, component values need to be changed. It is man-

datory for customers to change the external PLL component values when transitioning from revision D to

revision D1.

16.3.1 Identifying the Part Revision

The first line of the part marking on the package indicates the part number and package type

CS8420-xx. Table 17 shows a list of part revisions and their corresponding second line part marking,

which indicates what revision the part is.

Revision

D

D1

Pre-October 2002 (10-Digit)

Zxxxxxxxxx

Rxxxxxxxxx

New (12-Digit)

ZFBADXxxxxxx

RFBAD1xxxxxx

Table 17. Second Line Part Marking

88

DS245F4

Share Link: