AR1010T-I/ML(2016) データシートの表示（PDF） - Microchip Technology
部品番号
コンポーネント説明
メーカー
AR1010T-I/ML Datasheet PDF : 61 Pages
| |||
AR1000 SERIES RESISTIVE TOUCH SCREEN CONTROLLER
5.7 Timing – Bit Details
5.7.1 BIT RATE
The SPI standard does not specify a maximum data
rate for the serial bus. In general, SPI data rates can be
in MHz. Peripherals devices, such as the AR1021
controller, specify their own unique maximum SPI data
rates.
The maximum SPI bit rate for the AR1021 controller is
~900 kHz.
Characterization has been performed at bit rates of ~39
kHz and ~156 kHz.
FIGURE 5-4:
SPI BIT TIMING – DETAIL
5.7.2 INTER-BYTE DELAY
The AR1021 controller requires an inter-byte delay of
~50 us. This means the host should wait ~50 us
between the end of clocking a given byte and the start
of clocking the next byte.
5.7.3 BIT TIMING – DETAIL
Characterized timing details are shown below, in
Figure 5-4.
TABLE 5-3: SPI BIT TIMING MIN. AND MAX. VALUES
Parameter Number(1)
Parameter Description
10
SS↓ (select) to SCK↑ (initial)
11
SCK high
12
SCK low
13
SCK↓ (last) to SS↑ (deselect)
14
SDI setup before SCK↓
15
SDI hold after SCK↓
16
SDO valid after SCK↓
17
SDO↑ rise
18
SDO↓ fall
19
SS↑ (deselect) to SDO High-z
Note 1: Parameters are characterized, but not tested.
Min.
500
550
550
800
100
100
—
—
—
10
Max.
—
—
—
—
—
—
150
50
50
50
Units
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
2009-2016 Microchip Technology Inc.
DS40001393C-page 21
Share Link: 