ST72F324J6TATX データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

ST72F324J6TATX

8-bit MCU for automotive, 3.8 to 5.5V operating range with 8 to 32 Kbyte Flash, 10-bit ADC, 4 timers, SPI, SCI

STMicroelectronics 

Known limitations

ST72324xx-Auto

RIM ; reset the interrupt mask

LD A,sema ; check the semaphore status

CP A,#$01

jrne OUT

call call_routine ; call the interrupt routine

RIM

OUT:RIM

JP while_loop

.call_routine ; entry to call_routine

PUSH A

PUSH X

PUSH CC

.ext1_rt ; entry to interrupt routine

LD A,#$00

t(s) LD sema,A

IRET

bsolete Produc 15.3

Unexpected reset fetch

If an interrupt request occurs while a “POP CC” instruction is executed, the interrupt

controller does not recognize the source of the interrupt and, by default, passes the reset

vector address to the CPU.

Workaround

To solve this issue, a “POP CC” instruction must always be preceded by a “SIM” instruction.

t(s) - O 15.4

Obsolete Produc Note:

Clearing active interrupts outside interrupt routine

When an active interrupt request occurs at the same time as the related flag is being

cleared, an unwanted reset may occur.

Clearing the related interrupt mask will not generate an unwanted reset.

Concurrent interrupt context

The symptom does not occur when the interrupts are handled normally, that is, when:

● The interrupt flag is cleared within its own interrupt routine

● The interrupt flag is cleared within any interrupt routine

● The interrupt flag is cleared in any part of the code while this interrupt is disabled

If these conditions are not met, the symptom can be avoided by implementing the following

sequence:

Perform SIM and RIM operation before and after resetting an active interrupt request.

Example:

– SIM

– Reset interrupt flag

– RIM

188/193

Doc ID 13841 Rev 1

Share Link: