STM32F103T8U7TR 데이터 시트보기 (PDF) - STMicroelectronics
부품명
상세내역
제조사
STM32F103T8U7TR
STMicroelectronics
STM32F103T8U7TR Datasheet PDF : 123 Pages
| |||
STM32F103xC, STM32F103xD, STM32F103xE
5
Electrical characteristics
Electrical characteristics
5.1
5.1.1
5.1.2
5.1.3
5.1.4
5.1.5
Parameter conditions
Unless otherwise specified, all voltages are referenced to VSS.
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3).
Typical values
Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 3.3 V (for the
2 V VDD 3.6 V voltage range). They are given only as design guidelines and are not
tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2).
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in Figure 10.
Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 11.
Figure 10. Pin loading conditions
Figure 11. Pin input voltage
C = 50 pF
STM32F103xx pin
ai14141
STM32F103xx pin
VIN
ai14142
Doc ID 14611 Rev 7
39/123
Share Link: 