CDB5376 데이터 시트보기 (PDF) - Cirrus Logic

부품명

상세내역

제조사

CDB5376

Multichannel Seismic Evaluation System

Cirrus Logic 

CDB5376

3.3.5 Gain/Offset

The Gain / Offset sub-panel controls the digital filter GAIN and OFFSET registers for each channel.

The OFFSET and GAIN registers can be manually written with any 24-bit 2’s complement value from

0x800000 to 0x7FFFFF. The USEGR, USEOR, ORCAL, and EXP[4:0] values enable gain correction, off-

set correction, and offset calibration in the digital filter.

The offset calibration routine built into the digital filter is enabled by writing the ORCAL and EXP[4:0] bits.

The EXP[4:0] value can range from 0x00 to 0x18 and represents an exponential shift of the calibration

feedback, as described in the digital filter data sheet. Offset calibration results are automatically written to

the OFFSET registers and remain there, even after offset calibration is disabled.

Control

Gain

Offset

Read

Write

USEGR

USEOR

ORCAL

EXP[4:0]

Description

Displays the digital filter GAIN1 to GAIN4 registers.

Displays the digital filter OFFSET1 to OFFSET4 registers.

Reads values from the GAIN and OFFSET registers.

Writes values to the GAIN and OFFSET registers.

Enables gain correction. When enabled, output samples are gained down by the

value in the GAIN register.(Output = GAIN / 0x7FFFFF).

Enables offset correction. When enabled, output samples are offset by the value in

the OFFSET register. (Output = Sample - OFFSET).

Enables offset calibration using the exponent value from the EXP[4:0] control.

Results are automatically written to the OFFSET registers as they are calculated.

Sets the exponential value used by offset calibration.

42

DS612DB2

Share Link: