ST92F124JDV1TC 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

ST92F124JDV1TC

8/16-BIT SINGLE VOLTAGE FLASH MCU FAMILY WITH RAM, E³ ™ (EMULATED EEPROM), CAN 2.0B AND J1850 BLPD

STMicroelectronics 

ST92F124/F150/F250 - RESET AND CLOCK CONTROL UNIT (RCCU)

7.3 CLOCK MANAGEMENT

The various programmable features and operating modes of the CCU are handled by four registers:

– MODER (Mode Register)

This is a System Register (R235, Group E).

– CLK_FLAG (Clock Flag Register)

This is a Paged Register (R242, Page 55).

The input clock divide-by-two and the CPU clock

prescaler factors are handled by this register.

This register contains various status flags, as

well as control bits for clock selection.

– CLKCTL (Clock Control Register)

This is a Paged Register (R240, Page 55).

The low power modes, the RCCU interrupts and

the interpretation of the HALT instruction are

handled by this register.

– PLLCONF (PLL Configuration Register)

This is a Paged Register (R246, Page 55).

PLL management is programmed in this register.

Figure 61. Clock Control Unit Programming

XTSTOP

(CLK_FLAG)

DIV2

(MODER)

CSU_CKSEL

(CLK_FLAG)

CKAF_SEL

(CLKCTL)

1/16

1/4

CK_128

0

0

PLL

0

1

Crystal

oscillator

1/2

x

1 CLOCK2 6/8/10/14

1/N

1

CLOCK1

CK_AF

source CK_AF

0

INTCLK

1

to

Peripherals

and

CPU Clock Prescaler

MX[1:0] DX[2:0]

(PLLCONF)

XT_DIV16 CKAF_ST

(CLK_FLAG)

Wait for Interrupt and Low Power Modes:

LPOWFI (CLKCTL) selects Low Power operation automatically on entering WFI mode.

WFI_CKSEL (CLKCTL) selects the CK_AF clock automatically, if present, on entering WFI mode.

XTSTOP (CLK_FLAG) automatically stops the crystal oscillator when the CK_AF clock is present and selected.

128/429

9

Share Link: