STM8AF62A8TCU 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

STM8AF62A8TCU

Automotive 8-bit MCU, with up to 128 Kbyte Flash, data EEPROM, 10-bit ADC, timers, LIN, CAN, USART, SPI, I2C, 3 to 5.5 V

STMicroelectronics 

STM8AF526x/8x/Ax STM8AF6269/8x/Ax

Option bytes

Table 19. Option byte description (continued)

Option byte no.

Description

LSI_EN: Low speed internal clock enable

0: LSI clock is not available as CPU clock source

1: LSI clock is available as CPU clock source

OPT3

IWDG_HW: Independent watchdog

0: IWDG Independent watchdog activated by software

1: IWDG Independent watchdog activated by hardware

WWDG_HW: Window watchdog activation

0: WWDG window watchdog activated by software

1: WWDG window watchdog activated by hardware

WWDG_HALT: Window watchdog reset on Halt

0: No reset generated on Halt if WWDG active

1: Reset generated on Halt if WWDG active

EXTCLK: External clock selection

0: External crystal connected to OSCIN/OSCOUT

1: External clock signal on OSCIN

OPT4

CKAWUSEL: Auto-wakeup unit/clock

0: LSI clock source selected for AWU

1: HSE clock with prescaler selected as clock source for AWU

PRSC[1:0]: AWU clock prescaler

00: 24 MHz to 128 kHz prescaler

01: 16 MHz to 128 kHz prescaler

10: 8 MHz to 128 kHz prescaler

11: 4 MHz to 128 kHz prescaler

OPT5

HSECNT[7:0]: HSE crystal oscillator stabilization time

This configures the stabilization time to 0.5, 8, 128, and 2048 HSE cycles

with corresponding option byte values of 0xE1, 0xD2, 0xB4, and 0x00.

OPT6

TMU[3:0]: Enable temporary memory unprotection

0101: TMU disabled (permanent ROP).

Any other value: TMU enabled.

OPT7

WAIT STATE: Wait state configuration

This option configures the number of wait states inserted when reading

from the Flash/data EEPROM memory.

0: No wait state

1: One wait state

OPT8

TMU_KEY 1 [7:0]: Temporary unprotection key 0

Temporary unprotection key: Must be different from 0x00 or 0xFF

OPT9

TMU_KEY 2 [7:0]: Temporary unprotection key 1

Temporary unprotection key: Must be different from 0x00 or 0xFF

OPT10

TMU_KEY 3 [7:0]: Temporary unprotection key 2

Temporary unprotection key: Must be different from 0x00 or 0xFF

OPT11

TMU_KEY 4 [7:0]: Temporary unprotection key 3

Temporary unprotection key: Must be different from 0x00 or 0xFF

DocID14395 Rev 15

57/125

114

Share Link: