STM32F373RBT7(2013) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

STM32F373RBT7
(Rev.:2013)

ARM Cortex-M4 32b MCU+FPU, up to 256KB Flash+32KB SRAM timers, 4 ADCs (12/16-bit), 3 DACs, 2 comp., 2.0-3.6 V operation

STMicroelectronics 

Electrical characteristics

STM32F37xxx

6.3.11

EMC characteristics

Susceptibility tests are performed on a sample basis during device characterization.

Functional EMS (electromagnetic susceptibility)

While a simple application is executed on the device (toggling 2 LEDs through I/O ports).

the device is stressed by two electromagnetic events until a failure occurs. The failure is

indicated by the LEDs:

• Electrostatic discharge (ESD) (positive and negative) is applied to all device pins until

a functional disturbance occurs. This test is compliant with the IEC 61000-4-2 standard.

• FTB: A Burst of Fast Transient voltage (positive and negative) is applied to VDD and

VSS through a 100 pF capacitor, until a functional disturbance occurs. This test is

compliant with the IEC 61000-4-4 standard.

A device reset allows normal operations to be resumed.

The test results are given in Table 47. They are based on the EMS levels and classes

defined in application note AN1709.

Symbol

Table 47. EMS characteristics

Parameter

Conditions

VFESD

VEFTB

Voltage limits to be applied on any I/O pin

to induce a functional disturbance

VDD = 3.3 V, LQFP100, TA = +25 °C,

fHCLK = 72 MHz

conforms to IEC 61000-4-2

Fast transient voltage burst limits to be VDD = 3.3 V, LQFP100, TA = +25 °C,

applied through 100 pF on VDD and VSS fHCLK = 72 MHz

pins to induce a functional disturbance conforms to IEC 61000-4-4

Level/

Class

3B

4A

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and

prequalification tests in relation with the EMC level requested for his application.

Software recommendations

The software flowchart must include the management of runaway conditions such as:

• Corrupted program counter

• Unexpected reset

• Critical Data corruption (control registers...)

Prequalification trials

Most of the common failures (unexpected reset and program counter corruption) can be

reproduced by manually forcing a low state on the NRST pin or the Oscillator pins for 1

second.

80/131

DocID022691 Rev 4

Share Link: