ST72334J4TC Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

производитель

ST72334J4TC

8-bit MCU for automotive with single voltage Flash/ROM memory, ADC, 16-bit timers, SPI, SCI interfaces

STMicroelectronics 

ST72334xx-Auto, ST72314xx-Auto, ST72124Jx-Auto

I/O PORTS (Cont’d)

CAUTION: The alternate function must not be ac-

tivated as long as the pin is configured as input

with interrupt, in order to avoid generating spurious

interrupts.

Analog alternate function

When the pin is used as an ADC input, the I/O

must be configured as floating input. The analog

multiplexer (controlled by the ADC registers)

switches the analog voltage present on the select-

ed pin to the common analog rail which is connect-

ed to the ADC input.

It is recommended not to change the voltage level

or loading on any port pin while conversion is in

progress. Furthermore it is recommended not to

have clocking pins located close to a selected an-

alog pin.

WARNING: The analog input voltage level must

be within the limits stated in the absolute maxi-

mum ratings.

11.3 I/O PORT IMPLEMENTATION

The hardware implementation on each I/O port de-

pends on the settings in the DDR and OR registers

and specific feature of the I/O port such as ADC In-

put or true open drain.

Switching these I/O ports from one state to anoth-

er should be done in a sequence that prevents un-

wanted side effects. Recommended safe transi-

tions are illustrated in Figure 26. Other transitions

are potentially risky and should be avoided, since

they are likely to present unwanted side-effects

such as spurious interrupt generation.

Figure 26. Interrupt I/O Port State Transitions

Standard Ports

PA5:4, PC7:0, PD7:0, PE7:4, PE1:0, PF7:6, PF4

MODE

floating input

pull-up input

open drain output

push-pull output

DDR OR

0

0

0

1

1

0

1

1

Interrupt Ports

PA2:0, PB7:5, PB2:0, PF1:0 (with pull-up)

MODE

floating input

pull-up interrupt input

open drain output

push-pull output

DDR OR

0

0

0

1

1

0

1

1

PA3, PB4, PB3, PF2 (without pull-up)

MODE

floating input

floating interrupt input

open drain output

push-pull output

DDR OR

0

0

0

1

1

0

1

1

True Open Drain Ports

PA7:6

MODE

floating input

open drain (high sink ports)

DDR

0

1

01

00

10

11

INPUT

INPUT

OUTPUT

floating/pull-up floating open-drain

interrupt (reset state)

OUTPUT

push-pull

XX = DDR, OR

The I/O port register configurations are summa-

rized as follows.

43/150

Share Link: