TS4871ID 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

TS4871ID

OUTPUT RAIL TO RAIL 1W AUDIO POWER AMPLIFIER WITH STANDBY MODE

STMicroelectronics 

TS4871

Fig. 83 : SO8 & MiniSO8 Demoboard Top

Solder Layer

The output power is:

Pout = (2 Vout RMS )2 (W)

RL

For the same power supply voltage, the output

power in BTL configuration is four times higher

than the output power in single ended

configuration.

s Gain In Typical Application Schematic

(see page 1)

In flat region (no effect of Cin), the output voltage

of the first stage is:

Vout1 = –Vin R-----fR--e---i-e-n---d---- (V)

Fig. 84 : SO8 & MiniSO8 Demoboard Bottom Solder

Layer

For the second stage : Vout2 = -Vout1 (V)

The differential output voltage is:

Vout2 – Vo ut1 = 2Vin R-----f-R-e---i-e-n---d---- (V)

The differential gain named gain (Gv) for more

convenient usage is:

Gv = -V----o---u---t--2--V---–--i--nV-----o---u----t--1-- = 2 R-----fR--e---i-e-n---d----

s BTL Configuration Principle

The TS4871 is a monolithic power amplifier with a

BTL output type. BTL (Bridge Tied Load) means

that each end of the load is connected to two

single ended output amplifiers. Thus, we have :

Single ended output 1 = Vout1 = Vout (V)

Single ended output 2 = Vout2 = -Vout (V)

And Vout1 - Vout2 = 2Vout (V)

Remark : Vout2 is in phase with Vin and Vout1 is

180 phased with Vin. It means that the positive

terminal of the loudspeaker should be connected

to Vout2 and the negative to Vout1.

s Low and high frequency response

In low frequency region, the effect of Cin starts.

Cin with Rin forms a high pass filter with a -3dB cut

off frequency.

FCL = --2----π------R---1--i-n------C----i-n-- (Hz)

In high frequency region, you can limit the

bandwidth by adding a capacitor (Cfeed) in

parallel on Rfeed. Its form a low pass filter with a

-3dB cut off frequency.

FCH = --2----π------R-----f--e---1-e---d------C----f--e---e----d- (Hz)

20/28

Share Link: