ST10F269-Q3 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

ST10F269-Q3

16-BIT MCU WITH MAC UNIT, 256K BYTE FLASH MEMORY AND 12K BYTE RAM

STMicroelectronics 

ST10F269

16.1 - RTC registers

16.1.1 - RTCCON: RTC Control Register

The functions of the RTC are controlled by the RTCCON control register. If the RTOFF bit is set, the RTC

dividers and counters clock is disabled and registers can be written, when the ST10 chip enters power

down mode the clock oscillator will be switch off. The RTC has 2 interrupt sources, one is triggered every

basic clock period, the other one is the alarm.

RTCCON includes an interrupt request flag and an interrupt enable bit for each of them. This register is

read and written via the XBUS.

RTCCON (EC00h)

XBUS

Reset Value: --00h

15 14 13 12 11 10 9 8

7

6

5

4

3

2

1

0

- - - - - - - - RTCOFF -

-

- RTCAEN RTCAIR RTCSEN RTCSIR

RW

RW

RW

RW

RW

RTCOFF 2

RTCAEN 2

RTCAIR 1

RTCSEN 2

RTCSIR 1

RTC Switch Off Bit

‘0’: clock oscillator and RTC keep on running even if ST10 in power down mode

‘1’: clock oscillator is switch off if ST10 enters power down mode, RTC dividers and

counters are stopped and registers can be written

RTC Alarm Interrupt ENable

‘0’: RTCAI is disabled

‘1’: RTCAI is enabled, it is generated every n seconds

RTC Alarm Interrupt Request flag (when the alarm is triggered)

‘0’: the bit was reseted less than a n seconds ago

‘1’: the interrupt was triggered

RTC Second interrupt ENable

‘0’: RTCSI is disabled

‘1’: RTCSI is enabled, it is generated every second

RTC Second Interrupt Request flag (every second)

‘0’: the bit was reseted less than a second ago

‘1’: the interrupt was triggered

Notes: 1. As RTCCON register is not bit-addressable, the value of these bits must be read by checking their associated CCxIC register.

The 2 RTC interrupt signals are connected to Port2 in order to trigger an external interrupt that wake up the chip when in power down

mode.

2. All the bit of RTCCON are active high.

100/160

Share Link: