Z8F041APJ020EG 查看數據表（PDF） - Zilog

零件编号

产品描述 (功能)

生产厂家

Z8F041APJ020EG

High-Performance 8-Bit Microcontrollers Z8 Encore! XP® F082A Series

Zilog 

Z8 Encore! XP® F082A Series

Product Specification

32

Low-Power Modes

The Z8 Encore! XP F082A Series products contain power-saving features. The highest

level of power reduction is provided by the STOP Mode, in which nearly all device func-

tions are powered down. The next lower level of power reduction is provided by the

HALT Mode, in which the CPU is powered down.

Further power savings can be implemented by disabling individual peripheral blocks

while in Active mode (defined as being in neither STOP nor HALT Mode).

STOP Mode

Executing the eZ8 CPU’s STOP instruction places the device into STOP Mode, powering

down all peripherals except the Voltage Brown-Out detector, the Low-power Operational

Amplifier and the Watchdog Timer. These three blocks may also be disabled for additional

power savings. Specifically, the operating characteristics are:

• Primary crystal oscillator and internal precision oscillator are stopped; XIN and XOUT

(if previously enabled) are disabled and PA0/PA1 revert to the states programmed by

the GPIO registers

• System clock is stopped

• eZ8 CPU is stopped

• Program counter (PC) stops incrementing

• Watchdog Timer’s internal RC oscillator continues to operate if enabled by the Oscil-

lator Control Register

• If enabled, the Watchdog Timer logic continues to operate

• If enabled for operation in STOP Mode by the associated Flash option bit, the Voltage

Brown-Out protection circuit continues to operate

• Low-power operational amplifier continues to operate if enabled by the Power Control

Register

• All other on-chip peripherals are idle

To minimize current in STOP Mode, all GPIO pins that are configured as digital inputs

must be driven to one of the supply rails (VCC or GND). Additionally, any GPIOs config-

ured as outputs must also be driven to one of the supply rails. The device can be brought

out of STOP Mode using Stop Mode Recovery. For more information about Stop Mode

Recovery, see the Reset, Stop Mode Recovery and Low Voltage Detection chapter on

page 22.

PS022827-1212

PRELIMINARY

Low-Power Modes

Share Link: