Electrical characteristics
STM32F20xxx
Table 21. Typical and maximum current consumptions in Stop mode(1)
Symbol Parameter
Conditions
Typ
TA =
25 °C
TA =
25 °C
Max
TA =
85 °C
TA = Unit
105 °C
Flash in Stop mode, low-speed and high-speed
Supply current internal RC oscillators and high-speed oscillator 0.55
in Stop mode OFF (no independent watchdog)
with main
Flash in Deep power down mode, low-speed
regulator in and high-speed internal RC oscillators and
Run mode high-speed oscillator OFF (no independent
0.50
watchdog)
IDD_STOP
Flash in Stop mode, low-speed and high-speed
Supply current internal RC oscillators and high-speed oscillator 0.35
in Stop mode OFF (no independent watchdog)
with main
regulator in Flash in Deep power down mode, low-speed
Low Power
mode
and high-speed internal RC oscillators and
high-speed oscillator OFF (no independent
0.30
watchdog)
1.2 11.00 20.00
1.2 11.00 20.00
mA
1.1 8.00 15.00
1.1 8.00 15.00
1. All typical and maximum values will be further reduced by up to 50% as part of ST continuous improvement of test
procedures. New versions of the datasheet will be released to reflect these changes.
Figure 27. Typical current consumption vs temperature in Stop mode
10
Idd_stop_mr_flhstop
Idd_stop_mr_flhdeep
Idd_stop_lp_flhstop
Idd_stop_lp_flhdeep
1
0.1
0.01
-45 -35 -25 -15 -5 5 15 25 35 45 55 65 75 85 95 105
Temperature (°C)
MS19020V1
1. All typical and maximum values from table 18 and figure 26 will be reduced over time by up to 50% as part
of ST continuous improvement of test procedures. New versions of the datasheet will be released to reflect
these changes
76/177
Doc ID 15818 Rev 9