DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

PIC16F83-04I/SS 查看數據表(PDF) - Microchip Technology

零件编号
产品描述 (功能)
生产厂家
PIC16F83-04I/SS
Microchip
Microchip Technology 
PIC16F83-04I/SS Datasheet PDF : 124 Pages
First Prev 41 42 43 44 45 46 47 48 49 50 Next Last
PIC16F8X
8.11 Watchdog Timer (WDT)
The Watchdog Timer is a free running on-chip RC
oscillator which does not require any external
components. This RC oscillator is separate from the
RC oscillator of the OSC1/CLKIN pin. That means that
the WDT will run even if the clock on the OSC1/CLKIN
and OSC2/CLKOUT pins of the device has been
stopped, for example, by execution of a SLEEP
instruction. During normal operation a WDT time-out
generates a device RESET. If the device is in SLEEP
mode, a WDT Wake-up causes the device to wake-up
and continue with normal operation. The WDT can be
permanently disabled by programming configuration bit
WDTE as a '0' (Section 8.1).
8.11.1 WDT PERIOD
The WDT has a nominal time-out period of 18 ms, (with
no prescaler). The time-out periods vary with
temperature, VDD and process variations from part to
part (see DC specs). If longer time-out periods are
desired, a prescaler with a division ratio of up to 1:128
can be assigned to the WDT under software control by
writing to the OPTION_REG register. Thus, time-out
periods up to 2.3 seconds can be realized.
The CLRWDT and SLEEP instructions clear the WDT and
the postscaler (if assigned to the WDT) and prevent it
from timing out and generating a device
RESET condition.
The TO bit in the STATUS register will be cleared upon
a WDT time-out.
8.11.2 WDT PROGRAMMING CONSIDERATIONS
It should also be taken into account that under worst
case conditions (VDD = Min., Temperature = Max., max.
WDT prescaler) it may take several seconds before a
WDT time-out occurs.
FIGURE 8-18: WATCHDOG TIMER BLOCK DIAGRAM
From TMR0 Clock Source
(Figure 6-6)
WDT Timer
0
M
1U
X
WDT
Enable Bit
PSA
Postscaler
8
8 - to -1 MUX
PS2:PS0
0
1
MUX
To TMR0 (Figure 6-6)
PSA
WDT
Time-out
Note: PSA and PS2:PS0 are bits in the OPTION_REG register.
TABLE 8-7 SUMMARY OF REGISTERS ASSOCIATED WITH THE WATCHDOG TIMER
Address Name
Bit 7 Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Value on
Power-on
Reset
2007h Config. bits
(2)
(2)
(2)
(2)
PWRTE(1) WDTE FOSC1 FOSC0
(2)
81h
OPTION_
REG
RBPU INTEDG T0CS
T0SE
PSA
PS2
PS1
PS0
1111 1111
Legend: x = unknown. Shaded cells are not used by the WDT.
Note 1: See Figure 8-1 and Figure 8-2 for operation of the PWRTE bit.
2: See Figure 8-1, Figure 8-2 and Section 8.13 for operation of the Code and Data protection bits.
Value on all
other resets
1111 1111
DS30430C-page 50
© 1998 Microchip Technology Inc.

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]