ST92F250CV2TC 查看數據表（PDF） - STMicroelectronics
零件编号
产品描述 (功能)
生产厂家
ST92F250CV2TC
STMicroelectronics
ST92F250CV2TC Datasheet PDF : 429 Pages
| |||
ST92F124/F150/F250 - EXTERNAL MEMORY INTERFACE (EXTMI)
8 EXTERNAL MEMORY INTERFACE (EXTMI)
8.1 INTRODUCTION
The ST9 External Memory Interface uses two reg-
isters (EMR1 and EMR2) to configure external
memory accesses. Some interface signals are
also affected by WCR - R252 Page 0.
If the two registers EMR1 and EMR2 are set to the
proper values, the ST9+ memory access cycle is
similar to that of the original ST9, with the only ex-
ception that it is composed of just two system
clock phases, named T1 and T2.
During phase T1, the memory address is output on
the AS falling edge and is valid on the rising edge
of AS. Port1 and Port 9 maintain the address sta-
ble until the following T1 phase.
Figure 73. Page 21 Registers
During phase T2, two forms of behavior are possi-
ble. If the memory access is a Read cycle, Port 0
pins are released in high-impedance until the next
T1 phase and the data signals are sampled by the
ST9 on the rising edge of DS. If the memory ac-
cess is a Write cycle, on the falling edge of DS,
Port 0 outputs data to be written in the external
memory. Those data signals are valid on the rising
edge of DS and are maintained stable until the
next address is output.
Note that DS is pulled low at the beginning of
phase T2 only during an external memory access.
Page 21
FFh
FEh
FDh
FCh
FBh
FAh
F9h
DMASR
F8h
ISR
F7h
F6h
EMR2
F5h
EMR1
F4h
CSR
F3h
DPR3
F2h
DPR2
F1h
DPR1
F0h
DPR0
R255
R254
R253
R252
R251
R250
R249
R248
R247
R246
R245
R244
R243
R242
R241
R240
MMU
EXT.MEM
MMU
Relocation of P0-3 and DPR0-3 Registers
SSPL
SSPH
USPL
USPH
MODER
PPR
RP1
RP0
FLAGR
CICR
P5
P4
P3
P2
P1
P0
DMASR
ISR
EMR2
EMR1
CSR
DPR3
DPR2
DPR1
DPR0
Bit DPRREM=0
SSPL
SSPH
USPL
USPH
MODER
PPR
RP1
RP0
FLAGR
CICR
P5
P4
DPR3
DPR2
DPR1
DPR0
DMASR
ISR
EMR2
EMR1
CSR
P3
P2
P1
P0
Bit DPRREM=1
142/429
9
Share Link: 