MCP4014-502E/CH 查看數據表（PDF） - Microchip Technology

零件编号

产品描述 (功能)

生产厂家

MCP4014-502E/CH

Low-Cost 64-Step Volatile Digital POT

Microchip Technology 

MCP4011/2/3/4

5.2.1 INCREMENT

This mode is achieved by initializing the U/D pin to a

high state (VIH) prior to achieving a low state (VIL) on the

CS pin. Subsequent rising edges of the U/D pin

increment the wiper setting toward terminal A. This is

shown in Figure 5-1.

After the wiper is incremented to the desired position,

the CS pin should be forced to VIH to ensure that

“unexpected” transitions on the U/D pin do not cause

the wiper setting to increment. Driving the CS pin to VIH

should occur as soon as possible (within device

specifications) after the last desired increment occurs.

When the device voltage falls below the RAM retention

voltage of the device, the wiper state may be corrupted.

When the device returns to the operating range, the

wiper will be loaded with the default POR wiper setting.

After the CS pin is driven to VIH (from VIL), any other

serial command may immediately be entered.

Note:

The wiper value will not overflow. That is,

once the wiper value equals 0x3F,

subsequent increment commands are

ignored.

CS

U/D

Wiper

VIL

1

2

3

4

VIL

X

X+1 X+2

X+3 X+4

FIGURE 5-1:

Increment.

VIH

5

6 VIH

DS21978C-page 30

© 2006 Microchip Technology Inc.

Share Link: