PIC16LCR72-10I/SS 查看數據表（PDF） - Microchip Technology

零件编号

产品描述 (功能)

生产厂家

PIC16LCR72-10I/SS

8-Bit CMOS microcontroller with A,D converter

Microchip Technology 

PIC16C72 Series

8.4.1.1 ADDRESSING

Once the SSP module has been enabled, it waits for a

START condition to occur. Following the START condi-

tion, the 8-bits are shifted into the SSPSR register. All

incoming bits are sampled with the rising edge of the

clock (SCL) line. The value of register SSPSR<7:1> is

compared to the value of the SSPADD register. The

address is compared on the falling edge of the eighth

clock (SCL) pulse. If the addresses match, and the BF

and SSPOV bits are clear, the following events occur:

a) The SSPSR register value is loaded into the

SSPBUF register.

b) The buffer full bit, BF is set.

c) An ACK pulse is generated.

d) SSP interrupt flag bit, SSPIF (PIR1<3>) is set

(interrupt is generated if enabled) - on the falling

edge of the ninth SCL pulse.

In 10-bit address mode, two address bytes need to be

received by the slave. The five Most Significant bits

(MSbs) of the first address byte specify if this is a 10-bit

address. Bit R/W (SSPSTAT<2>) must specify a write

so the slave device will receive the second address

byte. For a 10-bit address the first byte would equal

‘1111 0 A9 A8 0’, where A9 and A8 are the two MSbs

of the address. The sequence of events for 10-bit

address is as follows, with steps 7- 9 for slave-transmit-

ter:

1. Receive first (high) byte of Address (bits SSPIF,

BF, and bit UA (SSPSTAT<1>) are set).

2. Update the SSPADD register with second (low)

byte of Address (clears bit UA and releases the

SCL line).

3. Read the SSPBUF register (clears bit BF) and

clear flag bit SSPIF.

4. Receive second (low) byte of Address (bits

SSPIF, BF, and UA are set).

5. Update the SSPADD register with the first (high)

byte of Address, if match releases SCL line, this

will clear bit UA.

6. Read the SSPBUF register (clears bit BF) and

clear flag bit SSPIF.

7. Receive repeated START condition.

8. Receive first (high) byte of Address (bits SSPIF

and BF are set).

9. Read the SSPBUF register (clears bit BF) and

clear flag bit SSPIF.

TABLE 8-3 DATA TRANSFER RECEIVED BYTE ACTIONS

Status Bits as Data

Transfer is Received

BF

SSPOV

0

0

1

0

1

1

0

1

SSPSR → SSPBUF

Yes

No

No

No

Generate ACK

Pulse

Yes

No

No

No

Set bit SSPIF

(SSP Interrupt occurs

if enabled)

Yes

Yes

Yes

Yes

DS39016A-page 48

Preliminary

© 1998 Microchip Technology Inc.

Share Link: