JS48F4400PCZ00 查看數據表（PDF） - Numonyx -> Micron
零件编号
产品描述 (功能)
生产厂家
JS48F4400PCZ00 Datasheet PDF : 102 Pages
| |||
Numonyx™ Wireless Flash Memory (W18)
Table 34: WAIT Signal Conditions
CONDITION
CE# = VIH
CE# = VIL
OE#
Synchronous Array Read
Synchronous Non-Array Read
All Asynchronous Read and all Write
Tri-State
Active
No-Effect
Active
Asserted
Asserted
WAIT
14.5
Data Hold (RCR[9])
The Data Output Configuration (DOC) bit (RCR[9]) determines whether a data word
remains valid on the data bus for one or two clock cycles. The processor’s minimum
data set-up time and the flash memory’s clock-to-data output delay determine whether
one or two clocks are needed.
A DOC set at 1-clock data hold corresponds to a 1-clock data cycle; a DOC set at 2-
clock data hold corresponds to a 2-clock data cycle. The setting of this configuration bit
depends on the system and CPU characteristics. For clarification, see Figure 39, “Data
Output Configuration with WAIT Signal Delay” on page 83.
A method for determining this configuration setting is shown below.
To set the device at 1-clock data hold for subsequent reads, the following condition
must be satisfied:
tCHQV (ns) + tDATA (ns) ≤ One CLK Period (ns)
As an example, use a clock frequency of 66 MHz and a clock period of 15 ns. Assume
the data output hold time is one clock. Apply this data to the formula above for the
subsequent reads:
11 ns + 4 ns ≤ 15 ns
This equation is satisfied, and data output will be available and valid at every clock
period. If tDATA is long, hold for two cycles.
During page-mode reads, the initial access time can be determined by the formula:
tADD-DELAY (ns) + tDATA (ns) + tAVQV (ns)
Subsequent reads in page mode are defined by:
tAPA (ns) + tDATA (ns)
(minimum time)
Datasheet
82
November 2007
Order Number: 290701-18
Share Link: 