ST72521AR9TB 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

ST72521AR9TB

8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC, FIVE TIMERS, SPI, SCI, I2C, CAN INTERFACE

STMicroelectronics 

ST72521

16-BIT TIMER (Cont’d)

10.4.7 Register Description

Each Timer is associated with three control and

status registers, and with six pairs of data registers

(16-bit values) relating to the two input captures,

the two output compares, the counter and the al-

ternate counter.

CONTROL REGISTER 1 (CR1)

Read/Write

Reset Value: 0000 0000 (00h)

7

0

ICIE OCIE TOIE FOLV2 FOLV1 OLVL2 IEDG1 OLVL1

Bit 7 = ICIE Input Capture Interrupt Enable.

0: Interrupt is inhibited.

1: A timer interrupt is generated whenever the

ICF1 or ICF2 bit of the SR register is set.

Bit 6 = OCIE Output Compare Interrupt Enable.

0: Interrupt is inhibited.

1: A timer interrupt is generated whenever the

OCF1 or OCF2 bit of the SR register is set.

Bit 5 = TOIE Timer Overflow Interrupt Enable.

0: Interrupt is inhibited.

1: A timer interrupt is enabled whenever the TOF

bit of the SR register is set.

Bit 4 = FOLV2 Forced Output Compare 2.

This bit is set and cleared by software.

0: No effect on the OCMP2 pin.

1: Forces the OLVL2 bit to be copied to the

OCMP2 pin, if the OC2E bit is set and even if

there is no successful comparison.

Bit 3 = FOLV1 Forced Output Compare 1.

This bit is set and cleared by software.

0: No effect on the OCMP1 pin.

1: Forces OLVL1 to be copied to the OCMP1 pin, if

the OC1E bit is set and even if there is no suc-

cessful comparison.

Bit 2 = OLVL2 Output Level 2.

This bit is copied to the OCMP2 pin whenever a

successful comparison occurs with the OC2R reg-

ister and OCxE is set in the CR2 register. This val-

ue is copied to the OCMP1 pin in One Pulse Mode

and Pulse Width Modulation mode.

Bit 1 = IEDG1 Input Edge 1.

This bit determines which type of level transition

on the ICAP1 pin will trigger the capture.

0: A falling edge triggers the capture.

1: A rising edge triggers the capture.

Bit 0 = OLVL1 Output Level 1.

The OLVL1 bit is copied to the OCMP1 pin when-

ever a successful comparison occurs with the

OC1R register and the OC1E bit is set in the CR2

register.

83/211

Share Link: