TS83C51RC2-VCKD 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

TS83C51RC2-VCKD

High Performance 8-bit Microcontrollers

Atmel Corporation 

TS80C51RA2/RD2

TS83C51RB2/RC2/RD2

TS87C51RB2/RC2/RD2

PCA Timer/Counter

CF CR

CCON

CCF4 CCF3 CCF2 CCF1 CCF0

0xD8

Module 0

Module 1

Module 2

To Interrupt

priority decoder

Module 3

Module 4

CMOD.0 ECF

ECCFn CCAPMn.0

IE.6

IE.7

EC

EA

Figure 8. PCA Interrupt System

PCA Modules: each one of the five compare/capture modules has six possible functions. It can perform:

• 16-bit Capture, positive-edge triggered,

• 16-bit Capture, negative-edge triggered,

• 16-bit Capture, both positive and negative-edge triggered,

• 16-bit Software Timer,

• 16-bit High Speed Output,

• 8-bit Pulse Width Modulator.

In addition, module 4 can be used as a Watchdog Timer.

Each module in the PCA has a special function register associated with it. These registers are: CCAPM0 for

module 0, CCAPM1 for module 1, etc. (See Table 10). The registers contain the bits that control the mode

that each module will operate in.

• The ECCF bit (CCAPMn.0 where n=0, 1, 2, 3, or 4 depending on the module) enables the CCF flag in the

CCON SFR to generate an interrupt when a match or compare occurs in the associated module.

• PWM (CCAPMn.1) enables the pulse width modulation mode.

• The TOG bit (CCAPMn.2) when set causes the CEX output associated with the module to toggle when there

is a match between the PCA counter and the module's capture/compare register.

• The match bit MAT (CCAPMn.3) when set will cause the CCFn bit in the CCON register to be set when there

is a match between the PCA counter and the module's capture/compare register.

• The next two bits CAPN (CCAPMn.4) and CAPP (CCAPMn.5) determine the edge that a capture input will

be active on. The CAPN bit enables the negative edge, and the CAPP bit enables the positive edge. If both

bits are set both edges will be enabled and a capture will occur for either transition.

• The last bit in the register ECOM (CCAPMn.6) when set enables the comparator function.

Table 11 shows the CCAPMn settings for the various PCA functions.

.

Rev. C - 06 March, 2001

27

Share Link: