STM32F100R8T7B(2010) 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

STM32F100R8T7B
(Rev.:2010)

Low & medium-density value line, advanced ARM-based 32-bit MCU with 16 to 128 KB Flash, 12 timers, ADC, DAC & 8 comm interfaces

STMicroelectronics 

STM32F100x4, STM32F100x6, STM32F100x8, STM32F100xB

Electrical characteristics

Table 21. HSE 4-24 MHz oscillator characteristics(1)(2)

Symbol

Parameter

Conditions

Min Typ Max Unit

fOSC_IN Oscillator frequency

4

8

24 MHz

RF Feedback resistor

200

k

CL1

CL2(3)

Recommended load capacitance

versus equivalent serial

resistance of the crystal (RS)(4)

RS = 30

30

pF

i2

HSE driving current

VDD = 3.3 V

VIN = VSS with 30 pF

load

1 mA

gm Oscillator transconductance

tSU(HSE)

(5)

Startup time

Startup

VDD is stabilized

25

2

mA/V

ms

1. Resonator characteristics given by the crystal/ceramic resonator manufacturer.

2. Based on characterization, not tested in production.

3. It is recommended to use high-quality external ceramic capacitors in the 5 pF to 25 pF range (typ.),

designed for high-frequency applications, and selected to match the requirements of the crystal or

resonator. CL1 and CL2, are usually the same size. The crystal manufacturer typically specifies a load

capacitance which is the series combination of CL1 and CL2. PCB and MCU pin capacitance must be

included (10 pF can be used as a rough estimate of the combined pin and board capacitance) when sizing

CL1 and CL2.

4. The relatively low value of the RF resistor offers a good protection against issues resulting from use in a

humid environment, due to the induced leakage and the bias condition change. However, it is

recommended to take this point into account if the MCU is used in tough humidity conditions.

5. tSU(HSE) is the startup time measured from the moment it is enabled (by software) to a stabilized 8 MHz

oscillation is reached. This value is measured for a standard crystal resonator and it can vary significantly

with the crystal manufacturer

Figure 19. Typical application with an 8 MHz crystal

Resonator with

integrated capacitors

CL1

CL2

8 MH z

resonator

REXT(1)

OSC_IN

RF

OSC_OU T

Bias

controlled

gain

fHS E

STM32F10xxx

ai14128b

1. REXT value depends on the crystal characteristics.

Low-speed external clock generated from a crystal/ceramic resonator

The low-speed external (LSE) clock can be supplied with a 32.768 kHz crystal/ceramic

resonator oscillator. All the information given in this paragraph are based on characterization

results obtained with typical external components specified in Table 22. In the application,

the resonator and the load capacitors have to be placed as close as possible to the oscillator

pins in order to minimize output distortion and startup stabilization time. Refer to the crystal

resonator manufacturer for more details on the resonator characteristics (frequency,

package, accuracy).

Doc ID 16455 Rev 2

47/84

Share Link: