AT90PWM2B-16SU 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

AT90PWM2B-16SU

8-bit Atmel Microcontroller with 8K Bytes In-System Programmable Flash

Atmel Corporation 

AT90PWM2/3/2B/3B

Thanks to this feature, we can for example configure two PSC in slave mode (PARUNn = 1 /

PRUNn = 0) and one PSC in master mode (PARUNm = 0 / PRUNm = 0). This PSC master can

start all PSC at the same moment (PRUNm = 1).

16.22.1

Fault events in Autorun mode

To complete this master/slave mechanism, fault event (input mode 7) is propagated from PSCn-

1 to PSCn and from PSCn to PSCn-1.

A PSC which propagate a Run signal to the following PSC stops this PSC when the Run signal

is deactivate.

According to the architecture of the PSC synchronization which build a “daisy-chain on the PSC

run signal” beetwen the three PSC, only the fault event (mode 7) which is able to “stop” the PSC

through the PRUN bits is transmited along this daisy-chain.

A PSC which receive its Run signal from the previous PSC transmits its fault signal (if enabled)

to this previous PSC. So a slave PSC propagates its fault events when they are configured and

enabled.

16.23 PSC Clock Sources

PSC must be able to generate high frequency with enhanced resolution.

Each PSC has two clock inputs:

• CLK PLL from the PLL

• CLK I/O

Figure 16-39. Clock selection

CLK

PLL

1

CLK

I/O

0

CK

PRESCALER

PCLKSELn

PPREn1/0

(1) : CK/16 for AT90PWM2/3

(2) : CK/64 for AT90PWM2/3

CLK PSCn

PCLKSELn bit in PSC n Configuration register (PCNFn) is used to select the clock source.

PPREn1/0 bits in PSC n Control Register (PCTLn) are used to select the divide factor of the

clock.

4317K–AVR–03/2013

161

Share Link: