STPCI2 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STPCI2

X86 CORE PC COMPATIBLE SYSTEM-ON-CHIP FOR TERMINALS

STMicroelectronics 

STPC® ATLAS

4.5. AC CHARACTERISTICS

This section lists the AC characteristics of the

STPC interfaces including output delays, input

setup requirements, input hold requirements and

output float delays. These measurements are

based on the measurement points identified in

Figure 4-1 and Figure 4-2. The rising clock edge

reference level VREF and other reference levels

are shown in Table 4-9 below. Input or output

signals must cross these levels during testing.

Figure 4-1 shows output delay (A and B) and input

setup and hold times (C and D). Input setup and

hold times (C and D) are specified minimums,

defining the smallest acceptable sampling window

a synchronous input signal must be stable for

correct operation.

Table 4-9. Drive Level and Measurement Points for Switching Characteristics

Symbol

Value

Units

VREF

1.5

V

VIHD

2.5

V

VILD

0.0

V

Note: Refer to Figure 4-1.

t(s) Figure 4-1. Drive Level and Measurement Points for Switching Characteristics

uc Tx

Prod CLK:

Obsolete OUTPUTS:

B

Valid

Output n

A

MIN

MAX

VRef

Valid

Output n+1

roduct(s) - INPUTS:

C

D

Valid

Input

Obsolete P LEGEND:

A - Maximum Output Delay Specification

B - Minimum Output Delay Specification

C - Minimum Input Setup Specification

D - Minimum Input Hold Specification

VIHD

VRef

VILD

VIHD

VRef

VILD

47/108

1

Share Link: