LH28F160S5D-L80 View Datasheet(PDF) - Sharp Electronics
Part Name
Description
Manufacturer
LH28F160S5D-L80
Sharp Electronics
LH28F160S5D-L80 Datasheet PDF : 55 Pages
| |||
LH28F160S5-L/S5H-L
Start
Write 70H
Read
Status Register
SR.7 = 0
1
Write 20H,
Block Address
Write D0H,
Block Address
Read
Status Register
SR.7 = 0
1
Full Status
Check if Desired
Block Erase
Complete
No
Suspend Block
Erase Loop
Suspend
Block Erase Yes
FULL STATUS CHECK PROCEDURE
Read Status Register
Data (See Above)
1
SR.3 =
0
1
SR.1 =
0
1
SR.4, 5 =
0
1
SR.5 =
0
Block Erase
Successful
VPP Range Error
Device Protect Error
Command Sequence
Error
Block Erase Error
BUS
OPERATION COMMAND
COMMENTS
Write
Read Status Data = 70H
Register Addr = X
Read
Status Register Data
Standby
Check SR.7
1 = WSM Ready
0 = WSM Busy
Write
Erase Setup
Data = 20H
Addr = Within Block to be Erased
Write
Erase
Confirm
Data = D0H
Addr = Within Block to be Erased
Read
Status Register Data
Standby
Check SR.7
1 = WSM Ready
0 = WSM Busy
Repeat for subsequent block erasures.
Full status check can be done after each block erase or after
a sequence of block erasures.
Write FFH after the last block erase operation to place device
in read array mode.
BUS
OPERATION COMMAND
COMMENTS
Standby
Check SR.3
1 = VPP Error Detect
Standby
Check SR.1
1 = Device Protect Detect
WP# = VIL, Block Lock-Bit is Set
Only required for systems implement-
ing block lock-bit configuration
Standby
Check SR.4, 5
Both 1 = Command Sequence Error
Standby
Check SR.5
1 = Block Erase Error
SR.5, SR.4, SR.3 and SR.1 are only cleared by the Clear
Status Register command in cases where multiple blocks
are erased before full status is checked.
If error is detected, clear the status register before attempting
retry or other error recovery.
Fig. 3 Automated Block Erase Flowchart
- 24 -
Share Link: 