PIC17LC752-08/JWQTP View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC17LC752-08/JWQTP

High-Performance 8-Bit CMOS EPROM Microcontrollers

Microchip Technology 

15.2.11 ACKNOWLEDGE SEQUENCE TIMING

An acknowledge sequence is enabled by setting the

acknowledge sequence enable bit, ACKEN

(SSPCON2<4>). When this bit is set, the SCL pin is

pulled low and the contents of the acknowledge data

bit is presented on the SDA pin. If the user wishes to

generate an acknowledge, then the ACKDT bit should

be cleared. If not, the user should set the ACKDT bit

before starting an acknowledge sequence. The baud

rate generator then counts for one rollover period

(TBRG), and the SCL pin is de-asserted (pulled high).

When the SCL pin is sampled high (clock arbitration),

the baud rate generator counts for TBRG . The SCL

pin is then pulled low for one TBRG. Following this,

the ACKEN bit is automatically cleared, the baud rate

generator is turned off, and the SSP module then goes

into IDLE mode. (Figure 15-32)

PIC17C75X

15.2.11.1 WCOL STATUS FLAG

If the user writes the SSPBUF when an acknowledege

sequence is in progress, then WCOL is set and the

contents of the buffer are unchanged (the write doesn’t

occur).

FIGURE 15-32: ACKNOWLEDGE SEQUENCE TIMING

Acknowledge sequence starts here

Write to SSPCON2

ACKEN = 1, ACKDT = 0

SDA

D0

SCL

8

TBRG

TBRG

ACK

9

ACKEN automatically cleared

SSPIF

Set SSPIF at the end

of receive

Note: TBRG= one baud rate generator period.

Cleared in

software

Cleared in

software

Set SSPIF at the end

of acknowledge sequence

© 1997 Microchip Technology Inc.

Preliminary

DS30264A-page 155

Share Link: