PIC18LF8520-IPT301 View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC18LF8520-IPT301

64/80-Pin High-Performance, 256 Kbit to 1 MbitEnhanced Flash Microcontrollers with A/D

Microchip Technology 

PIC18F6520/8520/6620/8620/6720/8720

4.14 RCON Register

The Reset Control (RCON) register contains flag bits

that allow differentiation between the sources of a

device Reset. These flags include the TO, PD, POR,

BOR and RI bits. This register is readable and writable.

REGISTER 4-4: RCON REGISTER

R/W-0

U-0

U-0

IPEN

—

—

bit 7

Note 1: If the BOREN configuration bit is set

(Brown-out Reset enabled), the BOR bit

is ‘1’ on a Power-on Reset. After a Brown-

out Reset has occurred, the BOR bit will

be cleared and must be set by firmware to

indicate the occurrence of the next

Brown-out Reset.

2: It is recommended that the POR bit be set

after a Power-on Reset has been

detected, so that subsequent Power-on

Resets may be detected.

R/W-1

RI

R/W-1

TO

R/W-1

PD

R/W-0

POR

R/W-0

BOR

bit 0

bit 7

bit 6-5

bit 4

bit 3

bit 2

bit 1

bit 0

IPEN: Interrupt Priority Enable bit

1 = Enable priority levels on interrupts

0 = Disable priority levels on interrupts (PIC16CXXX Compatibility mode)

Unimplemented: Read as ‘0’

RI: RESET Instruction Flag bit

1 = The RESET instruction was not executed

0 = The RESET instruction was executed causing a device Reset

(must be set in software after a Brown-out Reset occurs)

TO: Watchdog Time-out Flag bit

1 = After power-up, CLRWDT instruction, or SLEEP instruction

0 = A WDT time-out occurred

PD: Power-down Detection Flag bit

1 = After power-up or by the CLRWDT instruction

0 = By execution of the SLEEP instruction

POR: Power-on Reset Status bit

1 = A Power-on Reset has not occurred

0 = A Power-on Reset occurred (must be set in software after a Power-on Reset occurs)

BOR: Brown-out Reset Status bit

1 = A Brown-out Reset has not occurred

0 = A Brown-out Reset occurred (must be set in software after a Brown-out Reset occurs)

Legend:

R = Readable bit

- n = Value at POR

W = Writable bit

‘1’ = Bit is set

U = Unimplemented bit, read as ‘0’

‘0’ = Bit is cleared x = Bit is unknown

DS39609C-page 60

 2003-2013 Microchip Technology Inc.

Share Link: