C8051F045 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
Manufacturer
C8051F045 Datasheet PDF : 328 Pages
| |||
C8051F040/1/2/3/4/5/6/7
Performance
The CIP-51 employs a pipelined architecture that greatly increases its instruction throughput over the stan-
dard 8051 architecture. In a standard 8051, all instructions except for MUL and DIV take 12 or 24 system
clock cycles to execute, and usually have a maximum system clock of 12 MHz. By contrast, the CIP-51
core executes 70% of its instructions in one or two system clock cycles, with no instructions taking more
than eight system clock cycles.
With the CIP-51's maximum system clock at 25 MHz, it has a peak throughput of 25 MIPS. The CIP-51 has
a total of 109 instructions. The table below shows the total number of instructions that require each execu-
tion time.
Clocks to Execute
1
2
2/3
3
3/4
4
4/5
5
8
Number of Instructions 26
50
5
14
7
3
1
2
1
Programming and Debugging Support
A JTAG-based serial interface is provided for in-system programming of the Flash program memory and
communication with on-chip debug support logic. The re-programmable Flash can also be read and
changed a single byte at a time by the application software using the MOVC and MOVX instructions. This
feature allows program memory to be used for non-volatile data storage as well as updating program code
under software control.
The on-chip debug support logic facilitates full speed in-circuit debugging, allowing the setting of hardware
breakpoints and watch points, starting, stopping and single stepping through program execution (including
interrupt service routines), examination of the program's call stack, and reading/writing the contents of reg-
isters and memory. This method of on-chip debug is completely non-intrusive and non-invasive, requiring
no RAM, Stack, timers, or other on-chip resources.
The CIP-51 is supported by development tools from Silicon Labs and third party vendors. Silicon Labs pro-
vides an integrated development environment (IDE) including editor, macro assembler, debugger and pro-
grammer. The IDE's debugger and programmer interface to the CIP-51 via its JTAG interface to provide
fast and efficient in-system device programming and debugging. Third party macro assemblers and C
compilers are also available.
128
Rev. 1.5
Share Link: 