C8051F342 View Datasheet(PDF) - Silicon Laboratories

Part Name

Description

Manufacturer

C8051F342

Full Speed USB Flash MCU Family

Silicon Laboratories 

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D

11.1. Power-On Reset

During power-up, the device is held in a reset state and the RST pin is driven low until VDD settles above

VRST. A Power-On Reset delay (TPORDelay) occurs before the device is released from reset; this delay is

typically less than 0.3 ms. Figure 11.2. plots the power-on and VDD monitor reset timing.

On exit from a power-on reset, the PORSF flag (RSTSRC.1) is set by hardware to logic 1. When PORSF is

set, all of the other reset flags in the RSTSRC Register are indeterminate (PORSF is cleared by all other

resets). Since all resets cause program execution to begin at the same location (0x0000) software can

read the PORSF flag to determine if a power-up was the cause of reset. The content of internal data mem-

ory should be assumed to be undefined after a power-on reset. The VDD monitor is enabled following a

power-on reset.

Software can force a power-on reset by writing ‘1’ to the PINRSF bit in register RSTSRC.

2.70

2.4

VRST

VDD

2.0

1.0

t

RST

Logic HIGH

Logic LOW

TPORDelay

Power-On

Reset

VDD

Monitor

Reset

Figure 11.2. Power-On and VDD Monitor Reset Timing

Rev. 1.3

101

Share Link: