M29W128GL60N6E View Datasheet(PDF) - Numonyx -> Micron

Part Name

Description

Manufacturer

M29W128GL60N6E

128 Mbit (16 Mb x 8 or 8 Mbx 16, page, uniform block) 3 V supply Flash memory

Numonyx -> Micron 

Command interface

M29W128GH, M29W128GL

2. Grey cells represent Read cycles. The other cells are Write cycles.

3. DQ15 to DQ8 are ‘Don’t care’ during unlock and command cycles. A22 to A16 are ‘Don’t care’ during unlock and command cycles unless an address is required.

4. An Enter command sequence must be issued prior to any operation. It disables read and write operations from and to block 0. Read and write operations from any

other block are allowed.

5. DATA = Lock Register content.

6. Only one portion of password can be programmed or read by each Password Program command.

7. The password portion can be entered or read in any order as long as the entire 64-bit password is entered or read.

8. Protected and unprotected states correspond to 00 and 01, respectively.

9. The Clear all NVPBs command programs all NVPBs before erasure in order to prevent the over-erasure of previously cleared Non Volatile Modify Protection bits.

10. If an Entry Command Set command is issued, an Exit Protection Command Set command must be issued to return the device to Read mode.

48/94

Share Link: