PIC10F204T-I/OT(2014) View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC10F204T-I/OT
(Rev.:2014)

6-Pin, 8-Bit Flash Microcontrollers

Microchip Technology 

PIC10F200/202/204/206

TABLE 12-3: CALIBRATED INTERNAL RC FREQUENCIES – PIC10F200/202/204/206

AC CHARACTERISTICS

Standard Operating Conditions (unless otherwise specified)

Operating Temperature -40C  TA  +85C (industrial),

-40C  TA  +125C (extended)

Operating Voltage VDD range is described in

Section 12.1 “DC Characteristics: PIC10F200/202/204/206

(Industrial)”

Param.

No.

Sym.

Characteristic

Freq.

Tolerance

Min.

Typ.†

Max.

Units

Conditions

F10 FOSC Internal Calibrated

INTOSC Frequency(1,2)

1%

2%

3.96 4.00 4.04 MHz VDD=3.5V @ 25C

3.92 4.00 4.08 MHz 2.5V VDD  5.5V

0C  TA  +85C (industrial)

5%

3.80 4.00 4.20 MHz 2.0V VDD  5.5V

-40C  TA  +85C (industrial)

-40C  TA  +125C (extended)

* These parameters are characterized but not tested.

† Data in the Typical (“Typ.”) column is at 5V, 25C unless otherwise stated. These parameters are for

design guidance only and are not tested.

Note 1: To ensure these oscillator frequency tolerances, VDD and VSS must be capacitively decoupled as close to

the device as possible. 0.1 F and 0.01 F values in parallel are recommended.

2: Under stable VDD conditions.

FIGURE 12-3:

RESET, WATCHDOG TIMER AND DEVICE RESET TIMER TIMING –

PIC10F200/202/204/206

VDD

MCLR

Internal

POR

32

DRT

Timeout(2)

Internal

Reset

Watchdog

Timer

Reset

I/O pin(1)

30

32

32

31

34

34

Note 1: I/O pins must be taken out of High-Impedance mode by enabling the output drivers in software.

2: Runs on POR only.

DS40001239F-page 64

 2004-2014 Microchip Technology Inc.

Share Link: