PIC16LC773-I/SS View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16LC773-I/SS

28/40-Pin, 8-Bit CMOS Microcontrollers w/ 12-Bit A/D

Microchip Technology 

PIC16C77X

FIGURE 8-3: SSPCON2: SYNC SERIAL PORT CONTROL REGISTER2 (ADDRESS 91h)

R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0

GCEN AKSTAT AKDT AKEN RCEN PEN RSEN SEN R =Readable bit

bit7

bit0

W =Writable bit

U =Unimplemented bit,

Read as ‘0’

- n =Value at POR reset

bit 7: GCEN: General Call Enable bit (In I2C slave mode only)

1 = Enable interrupt when a general call address (0000h) is received in the SSPSR.

0 = General call address disabled.

bit 6:

AKSTAT: Acknowledge Status bit (In I2C master mode only)

In master transmit mode:

1 = Acknowledge was not received from slave

0 = Acknowledge was received from slave

bit 5:

AKDT: Acknowledge Data bit (In I2C master mode only)

In master receive mode:

Value that will be transmitted when the user initiates an Acknowledge sequence at the end of a receive.

1 = Not Acknowledge

0 = Acknowledge

bit 4:

AKEN: Acknowledge Sequence Enable bit (In I2C master mode only).

In master receive mode:

1 = Initiate Acknowledge sequence on SDA and SCL pins, and transmit AKDT data bit. Automatically

cleared by hardware.

0 = Acknowledge sequence idle

bit 3:

RCEN: Receive Enable bit (In I2C master mode only).

1 = Enables Receive mode for I2C

0 = Receive idle

bit 2:

PEN: Stop Condition Enable bit (In I2C master mode only).

SCK release control

1 = Initiate Stop condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Stop condition idle

bit 1:

RSEN: Repeated Start Condition Enabled bit (In I2C master mode only)

1 = Initiate Repeated Start condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Repeated Start condition idle.

bit 0:

SEN: Start Condition Enabled bit (In I2C master mode only)

1 = Initiate Start condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Start condition idle.

Note: For bits AKEN, RCEN, PEN, RSEN, SEN: If the I2C module is not in the idle mode, this bit may not be

set (no spooling), and the SSPBUF may not be written (or writes to the SSPBUF are disabled).

DS30275B-page 56

Advance Information

 1999-2013 Microchip Technology Inc.

Share Link: