PIC18LF4331T-I/SO View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC18LF4331T-I/SO

28/40/44-Pin Enhanced Flash Microcontrollers with nanoWatt Technology, High-Performance PWM and A/D

Microchip Technology 

PIC18F2331/2431/4331/4431

18.6.5

COMPLEMENTARY PWM

OPERATION

The Complementary mode of PWM operation is useful

to drive one or more power switches in half-bridge

configuration as shown in Figure 18-16. This inverter

topology is typical for a 3-phase induction motor,

brushless DC motor or a 3-phase Uninterruptible

Power Supply (UPS) control applications.

Each upper/lower power switch pair is fed by a

complementary PWM signal. Dead time may be

optionally inserted during device switching, where both

outputs are inactive for a short period (see

Section 18.7 “Dead-Time Generators”).

In Complementary mode, the duty cycle comparison

units are assigned to the PWM outputs as follows:

• PDC0 register controls PWM1/PWM0 outputs

• PDC1 register controls PWM3/PWM2 outputs

• PDC2 register controls PWM5/PWM4 outputs

• PDC3 register controls PWM7/PWM6 outputs

PWM1/3/5/7 are the main PWMs that are controlled by

the PDCx registers and PWM0/2/4/6 are the

complemented outputs. When using the PWMs to

control the half bridge, the odd numbered PWMs can

be used to control the upper power switch and the even

numbered PWMs used for the lower switches.

FIGURE 18-16:

+V

TYPICAL LOAD FOR

COMPLEMENTARY PWM

OUTPUTS

3-Phase

Load

The Complementary mode is selected for each PWM

I/O pin pair by clearing the appropriate PMODx bit in

the PWMCON0 register. The PWM I/O pins are set to

Complementary mode by default upon all kinds of

device Resets.

DS39616D-page 190

 2010 Microchip Technology Inc.

Share Link: