PIC16C65A/JW View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
PIC16C65A/JW Datasheet PDF : 108 Pages
| |||
9.3 Reset
The PIC16C62X differentiates between various kinds
of reset:
a) Power-on reset (POR)
b) MCLR reset during normal operation
c) MCLR reset during SLEEP
d) WDT reset (normal operation)
e) WDT wake-up (SLEEP)
f) Brown-out Reset (BOR)
Some registers are not affected in any reset condition;
their status is unknown on POR and unchanged in any
other reset. Most other registers are reset to a “reset
PIC16C62X
state” on Power-on reset, MCLR reset, WDT reset and
MCLR reset during SLEEP. They are not affected by a
WDT wake-up, since this is viewed as the resumption
of normal operation. TO and PD bits are set or cleared
differently in different reset situations as indicated in
Table 9-4. These bits are used in software to determine
the nature of the reset. See Table 9-7 for a full descrip-
tion of reset states of all registers.
A simplified block diagram of the on-chip reset circuit is
shown in Figure 9-7.
The MCLR reset path has a noise filter to detect and
ignore small pulses. See Table 12-6 for pulse width
specification.
FIGURE 9-7:
SIMPLIFIED BLOCK DIAGRAM OF ON-CHIP RESET CIRCUIT
External
Reset
MCLR/
VPP Pin
VDD
WDT
Module
SLEEP
WDT
Time-out
Reset
VDD rise
detect
Power-on Reset
Brown-out
Reset BOREN
S
OST/PWRT
OST
10-bit Ripple-counter
R
OSC1/
CLKIN
Pin
On-chip(1)
RC OSC
PWRT
10-bit Ripple-counter
Q
Chip_Reset
Q
Enable PWRT
Enable OST
See Table 9-3 for time-out situations.
Note 1: This is a separate oscillator from the RC oscillator of the CLKIN pin.
© 1998 Microchip Technology Inc.
Preliminary
DS30235G-page 49
Share Link: 