ST72C314N4B7(2003) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST72C314N4B7
(Rev.:2003)

8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, ADC, 16-BIT TIMERS, SPI, SCI INTERFACES

STMicroelectronics 

ST72334J/N, ST72314J/N, ST72124J

14 ON-CHIP PERIPHERALS

14.1 WATCHDOG TIMER (WDG)

14.1.1 Introduction

The Watchdog timer is used to detect the occur-

rence of a software fault, usually generated by ex-

ternal interference or by unforeseen logical condi-

tions, which causes the application program to

abandon its normal sequence. The Watchdog cir-

cuit generates an MCU reset on expiry of a pro-

grammed time period, unless the program refresh-

es the counter’s contents before the T6 bit be-

comes cleared.

14.1.2 Main Features

s Programmable timer (64 increments of 12288

CPU cycles)

s Programmable reset

s Reset (if watchdog activated) after a HALT

instruction or when the T6 bit reaches zero

Figure 29. Watchdog Block Diagram

s Hardware Watchdog selectable by option byte

s Watchdog Reset indicated by status flag (in

versions with Safe Reset option only)

14.1.3 Functional Description

The counter value stored in the CR register (bits

T[6:0]), is decremented every 12,288 machine cy-

cles, and the length of the timeout period can be

programmed by the user in 64 increments.

If the watchdog is activated (the WDGA bit is set)

and when the 7-bit timer (bits T[6:0]) rolls over

from 40h to 3Fh (T6 becomes cleared), it initiates

a reset cycle pulling low the reset pin for typically

500ns.

RESET

WDGA T6

WATCHDOG CONTROL REGISTER (CR)

T5 T4 T3 T2 T1 T0

7-BIT DOWNCOUNTER

fCPU

CLOCK DIVIDER

÷12288

49/153

Share Link: