PIC16C5X
19.6 Timing Diagrams and Specifications
FIGURE 19-2: EXTERNAL CLOCK TIMING - PIC16C5X, PIC16CR5X
Q4
OSC1
CLKOUT
Q1
Q2
Q3
Q4
Q1
1
3
3
4
4
2
TABLE 19-2: EXTERNAL CLOCK TIMING REQUIREMENTS - PIC16C5X, PIC16CR5X
AC Characteristics
Standard Operating Conditions (unless otherwise specified)
Operating Temperature
0°C ≤ TA ≤ +70°C (commercial)
–40°C ≤ TA ≤ +85°C (industrial)
–40°C ≤ TA ≤ +125°C (extended)
Operating Voltage VDD range is described in Section 19.1, Section 19.2 and Section 19.3.
Parameter
No.
Sym
Characteristic
Min Typ(1) Max Units
Conditions
FOSC External CLKIN Frequency(2)
DC —
4.0 MHz XT osc mode
DC —
4.0 MHz HS osc mode (04)
DC —
20 MHz HS osc mode (20)
Oscillator Frequency(2)
DC — 200 kHz LP osc mode
DC —
4.0 MHz RC osc mode
0.455 —
4.0 MHz XT osc mode
4
—
4.0 MHz HS osc mode (04)
4
—
20 MHz HS osc mode (20)
1
TOSC External CLKIN Period(2)
5
—
250 —
200 kHz LP osc mode
— ns XT osc mode
250 —
— ns HS osc mode (04)
50 —
— ns HS osc mode (20)
Oscillator Period(2)
5.0 —
250 —
— µs LP osc mode
— ns RC osc mode
250 — 2,200 ns XT osc mode
250 — 250 ns HS osc mode (04)
50 — 250 ns HS osc mode (20)
5.0 — 200 µs LP osc mode
* These parameters are characterized but not tested.
Note 1: Data in the Typical (“Typ”) column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
2: All specified values are based on characterization data for that particular oscillator type under standard operating condi-
tions with the device executing code. Exceeding these specified limits may result in an unstable oscillator operation and/or
higher than expected current consumption.
When an external clock input is used, the “max” cycle time limit is “DC” (no clock) for all devices.
3: Instruction cycle period (TCY) equals four times the input oscillator time base period.
DS30453B-page 178
Preliminary
© 1998 Microchip Technology Inc.