ST7FMC1M2T3 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST7FMC1M2T3

8-bit MCU with nested interrupts, Flash, 10-bit ADC, brushless motor control, five timers, SPI, LINSCI™

STMicroelectronics 

ST7MC1xx/ST7MC2xx

16-BIT TIMER

10.3.4 Low Power Modes

Wait

Halt

No effect on 16-bit Timer.

Timer interrupts cause the Device to exit from Wait mode.

16-bit Timer registers are frozen.

In Halt mode, the counter stops counting until Halt mode is exited. Counting resumes from the previous count

when the Device is woken up by an interrupt with “exit from Halt mode” capability or from the counter reset

value when the Device is woken up by a RESET.

If an input capture event occurs on the ICAPi pin, the input capture detection circuitry is armed. Consequent-

ly, when the Device is woken up by an interrupt with “exit from Halt mode” capability, the ICFi bit is set, and

the counter value present when exiting from Halt mode is captured into the ICiR register.

10.3.5 Interrupts

Input Capture 1 event/Counter reset in PWM mode

Input Capture 2 event

Output Compare 1 event (not available in PWM mode)

Output Compare 2 event (not available in PWM mode)

Timer Overflow event

Note:

ICF1

Yes

No

ICIE

ICF2

Yes

No

OCF1

Yes

No

OCIE

OCF2

Yes

No

TOF TOIE Yes

No

10.3.6 Summary of Timer modes

Input Capture (1 and/or 2)

Output Compare (1 and/or 2)

One Pulse Mode

PWM Mode

Yes

Yes

Yes

Yes

Yes

Yes

No

Not Recommended1)

No

No

Not Recommended3)

No

3) See note 4 in Section 10.3.3.6 Pulse Width Modulation Mode

Yes

Yes

Partially 2)

No

1

Share Link: