STM32F030F4P6 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F030F4P6

Value-line ARM®-based 32-bit MCU with up to 256-KB Flash, timers, ADC, communication interfaces, 2.4-3.6 V operation

STMicroelectronics 

STM32F030x4/x6/x8/xC

Electrical characteristics

Output driving current

The GPIOs (general purpose input/outputs) can sink or source up to +/-8 mA, and sink or

source up to +/- 20 mA (with a relaxed VOL/VOH).

In the user application, the number of I/O pins which can drive current must be limited to

respect the absolute maximum rating specified in Section 6.2:

• The sum of the currents sourced by all the I/Os on VDDIOx, plus the maximum

consumption of the MCU sourced on VDD, cannot exceed the absolute maximum rating

ΣIVDD (see Table 18: Voltage characteristics).

• The sum of the currents sunk by all the I/Os on VSS, plus the maximum consumption of

the MCU sunk on VSS, cannot exceed the absolute maximum rating ΣIVSS (see

Table 18: Voltage characteristics).

Output voltage levels

Unless otherwise specified, the parameters given in the table below are derived from tests

performed under the ambient temperature and supply voltage conditions summarized in

Table 21: General operating conditions. All I/Os are CMOS- and TTL-compliant (FT, TTa or

TC unless otherwise specified).

Table 47. Output voltage characteristics(1)

Symbol

Parameter

Conditions

Min

Max Unit

VOL

VOH

VOL(2)

VOH(2)

VOL(2)

VOH(2)

Output low level voltage for an I/O pin

Output high level voltage for an I/O pin

Output low level voltage for an I/O pin

Output high level voltage for an I/O pin

Output low level voltage for an I/O pin

Output high level voltage for an I/O pin

|IIO| = 8 mA

VDDIOx ≥ 2.7 V

|IIO| = 20 mA

VDDIOx ≥ 2.7 V

|IIO| = 6 mA

-

0.4

V

VDDIOx–0.4

-

-

1.3

V

VDDIOx–1.3

-

-

0.4

V

VDDIOx–0.4

-

VOLFm+(2)

Output low level voltage for an FTf I/O pin in

Fm+ mode

|IIO| = 20 mA

VDDIOx ≥ 2.7 V

|IIO| = 10 mA

-

0.4 V

-

0.4 V

1. The IIO current sourced or sunk by the device must always respect the absolute maximum rating specified in Table 18:

Voltage characteristics, and the sum of the currents sourced or sunk by all the I/Os (I/O ports and control pins) must always

respect the absolute maximum ratings ΣIIO.

2. Data based on characterization results. Not tested in production.

Input/output AC characteristics

The definition and values of input/output AC characteristics are given in Figure 20 and

Table 48, respectively.

Unless otherwise specified, the parameters given are derived from tests performed under

the ambient temperature and supply voltage conditions summarized in Table 21: General

operating conditions.

DocID024849 Rev 3

63/91

74

Share Link: