TS83C51RB2-VCJD View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

TS83C51RB2-VCJD

High Performance 8-bit Microcontrollers

Atmel Corporation 

TS80C51RA2/RD2

TS83C51RB2/RC2/RD2

TS87C51RB2/RC2/RD2

Symbol

Parameter

Min

ICC

Power Supply Current Maximum values, X1

idle

mode: (7)

Typ

Max

Unit Test Conditions

0.15 Freq

(MHz) + 0.2

@12MHz 2

mA VCC = 3.3 V(2)

@16MHz 2.6

NOTES

1. ICC under reset is measured with all output pins disconnected; XTAL1 driven with TCLCH, TCHCL = 5 ns (see Figure 24.), VIL = VSS + 0.5 V,

VIH = VCC - 0.5V; XTAL2 N.C.; EA = RST = Port 0 = VCC. ICC would be slightly higher if a crystal oscillator used..

2. Idle ICC is measured with all output pins disconnected; XTAL1 driven with TCLCH, TCHCL = 5 ns, VIL = VSS + 0.5 V, VIH = VCC - 0.5 V; XTAL2

N.C; Port 0 = VCC; EA = RST = VSS (see Figure 22.).

3. Power Down ICC is measured with all output pins disconnected; EA = VSS, PORT 0 = VCC; XTAL2 NC.; RST = VSS (see Figure 23.).

4. Capacitance loading on Ports 0 and 2 may cause spurious noise pulses to be superimposed on the VOLs of ALE and Ports 1 and 3. The noise is

due to external bus capacitance discharging into the Port 0 and Port 2 pins when these pins make 1 to 0 transitions during bus operation. In the worst

cases (capacitive loading 100pF), the noise pulse on the ALE line may exceed 0.45V with maxi VOL peak 0.6V. A Schmitt Trigger use is not necessary.

5. Typicals are based on a limited number of samples and are not guaranteed. The values listed are at room temperature and 5V.

6. Under steady state (non-transient) conditions, IOL must be externally limited as follows:

Maximum IOL per port pin: 10 mA

Maximum IOL per 8-bit port:

Port 0: 26 mA

Ports 1, 2, 3 and 4 and 5 when available: 15 mA

Maximum total IOL for all output pins: 71 mA

If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater than the listed test conditions.

7. For other values, please contact your sales office.

8. Operating ICC is measured with all output pins disconnected; XTAL1 driven with TCLCH, TCHCL = 5 ns (see Figure 24.), VIL = VSS + 0.5 V,

VIH = VCC - 0.5V; XTAL2 N.C.; EA = Port 0 = VCC; RST = VSS. The internal ROM runs the code 80 FE (label: SJMP label). ICC would be slightly

higher if a crystal oscillator is used. Measurements are made with OTP products when possible, which is the worst case.

VCC

ICC

VCC

VCC

P0

VCC

RST EA

(NC)

CLOCK

SIGNAL

XTAL2

XTAL1

VSS

All other pins are disconnected.

Figure 20. ICC Test Condition, under reset

60

Rev. C - 06 March, 2001

Share Link: