XE8802MI000 View Datasheet(PDF) - Semtech Corporation

Part Name

Description

Manufacturer

XE8802MI000

Sensing Machine Data Acquisition SoC with 16+10 bit ZoomingADC™ Embedded RISC controller and LCD driver

Semtech Corporation 

XE8802 Sensing Machine Data Acquisition MCU

with ZoomingADC™ and LCD driver

Important Note:

In the actual version of the Prostart, the NFASTREAD pin is hard wired to VBAT. Nevertheless, the Prostart

can be used to program the device for both modes by (un)checking the NFASTREAD selection box in the

software loader. If the user wants to run the software programmed in the NFASTREAD=0 mode, he will

need to build his own application board which connects NFASTREAD=VSS.

4.3 Quick reference data memory register map

The data register map is given in the tables below. A more detailed description of the different registers is given in

the detailed description of the different peripherals.

The tables give the following information:

1. The register name and register address

2. The different bits in the register

3. The access mode of the different bits (see Table 4-4-1 for code description)

4. The reset source and reset value of the different bits

The reset source coding is given in Table 4-4-2. To get a full description of the reset sources, please refer to the

reset block chapter.

code

r

w

r0

r1

c

c1

ca

s

access mode

bit can be read

bit can be written

bit always reads 0

bit always reads 1

bit is cleared by writing any value

bit is cleared by writing a 1

bit is cleared after reading

special function, verify the detailed description in the respective peripherals

Table 4-4-1. Access mode codes used in the register definitions

code

glob

cold

pconf

sleep

reset source

nresetglobal

nresetcold

nresetpconf

nresetsleep

Table 4-4-2. Reset source coding used in the register definitions

© Semtech 2006

www.semtech.com

4-3

Share Link: