TS68230 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

TS68230

HMOS PARALLEL INTERFACE/TIMER

STMicroelectronics 

TS68230

5. H4 may be an output pin in the pulsed input

handshake protocol. It is asserted exactly as in

the interlocked input protocol above, but never

remains asserted longer than four clock cycles.

Typically, a four clock cycle pulse is generated.

But in the case that a subsequent H3 asserted

edge occurs before termination of the pulse, H4

is negated asynchronously. Thus, anytime after

the leading edge of the H4 pulse, new data may

be entered in the double-buffered input latches.

The H4S status bit is always clear. When H34

enable is clear, H4 is held negated.

For pins used as outputs, the data path consists of

a single latch driving the output buffer. Data written

to the port’s data register does not affect the opera-

tion of any handshake pin, status bit, or any other as-

pect of the PI/T. Thus, output pins may be used

independently of the input transfer.

The programmable options of the H2 pin are :

1. H2 may be an edge-sensitive input pin inde-

pendent of H1 and the transfer of port data. On

the asserted edge of H2, the H2S status bit is

set. It is cleared by either the RESET pin being

asserted, writing a one to the particular status

bit in the port status register (PSR), or when the

H12 enable bit of the port general control re-

gister is clear.

2. H2 may be a general-purpose output pin that

is always negated. The H2S status bit is al-

ways clear.

3. H2 may be a general-purpose output pin that

is always asserted. The H2S status bit is al-

ways clear.

Programmable Options Mode 1 - Port A Submode XX and Port B Submode X0

PACR

76

00

PACR

543

0XX

1X0

1X1

PACR

2

0

1

PACR

1

0

1

PACR

0

X

PBCR

76

00

Port A Submode

Submode XX

H2 Control

Input pin - edge-sensitive status input, H2S is set on an asserted edge.

Output pin - negated, H2S is always cleared.

Output pin - asserted, H2S is always cleared.

H2 Interrupt Enable

The H2 interrupt is disabled.

The H2 interrupt is enabled.

H1 SVCRQ Enable

The H1 interrupt is disabled.

The H1 interrupt is enabled.

H1 Status Control.

H1 is an edge-sensitive status input. H1S is set by an asserted edge of H1.

Port B Submode

Submode X0.

27/61

Share Link: