ST92F250CV2 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST92F250CV2

8/16-bit single voltage Flash MCU family with RAM, E³ TM (emulated EEPROM), CAN 2.0B and J1850 BLPD

STMicroelectronics 

Pinout and pin description

ST92F124xx/ST92F150Cxx/ST92F150JDV1/ST92F250CV2

VSS. Digital Circuit Ground. Four pins are available on 100-pin versions, two on 64-pin

versions. The pins are internally connected.

VTEST Power Supply Voltage for Flash test purposes. This pin must be kept to 0 in user

mode.

VREG. Stabilization capacitors for the internal voltage regulator. The user must connect

external stabilization capacitors to these pins. Refer to Figure 16.

2.1

I/O port alternate functions

Each pin of the I/O ports of the ST92F124/F150/F250 may assume software programmable

Alternate Functions as shown in Section 4.

2.2

Termination of unused pins

For unused pins, input mode is not recommended. These pins must be kept at a fixed

voltage using the output push pull mode of the I/O or an external pull-up or pull-down

resistor.

28/523

Doc ID 8848 Rev 7

Share Link: