DSPIC33FJ32MC304-I/SP View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

DSPIC33FJ32MC304-I/SP

16-bit Digital Signal Controllers (up to 128 KB Flash and 16K SRAM) with Motor Control PWM and Advanced Analog

Microchip Technology 

dsPIC33FJ32MC302/304, dsPIC33FJ64MCX02/X04 AND dsPIC33FJ128MCX02/X04

TABLE 31-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS (CONTINUED)

DC CHARACTERISTICS

Standard Operating Conditions: 3.0V to 3.6V

(unless otherwise stated)

Operating temperature -40°C ≤ TA ≤ +85°C for Industrial

-40°C ≤ TA ≤ +125°C for Extended

Param

No.

Symbol

Characteristic

Min

Typ(1) Max Units

Conditions

IICL

Input Low Injection Current

DI60a

0

—

-5(5,8) mA All pins except VDD,

VSS, AVDD, AVSS,

MCLR, VCAP, SOSCI,

SOSCO, and RB14

IICH

Input High Injection Current

DI60b

0

— +5(6,7,8) mA All pins except VDD,

VSS, AVDD, AVSS,

MCLR, VCAP, SOSCI,

SOSCO, RB14, and

digital 5V-tolerant

designated pins

∑IICT

DI60c

Total Input Injection Current

(sum of all I/O and control

pins)

-20(9)

— +20(9) mA Absolute instantaneous

sum of all ± input

injection currents from

all I/O pins

( | IICL + | IICH | ) ≤ ∑IICT

Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.

2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels

represent normal operating conditions. Higher leakage current can be measured at different input voltages.

3: Negative current is defined as current sourced by the pin.

4: See “Pin Diagrams” for the 5V tolerant I/O pins.

5: VIL source < (VSS – 0.3). Characterized but not tested.

6: Non-5V tolerant pins VIH source > (VDD + 0.3), 5V tolerant pins VIH source > 5.5V. Characterized but not

tested.

7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5.5V.

8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.

9: Any number and/or combination of I/O pins not excluded under IICL or IICH conditions are permitted

provided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not

exceed the specified limit. Characterized but not tested.

DS70291G-page 366

© 2007-2012 Microchip Technology Inc.

Share Link: