STM32F373RBT7(2013) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F373RBT7
(Rev.:2013)

ARM Cortex-M4 32b MCU+FPU, up to 256KB Flash+32KB SRAM timers, 4 ADCs (12/16-bit), 3 DACs, 2 comp., 2.0-3.6 V operation

STMicroelectronics 

STM32F37xxx

Electrical characteristics

Note:

For CL1 and CL2, it is recommended to use high-quality external ceramic capacitors in the

5 pF to 20 pF range (typ.), designed for high-frequency applications, and selected to match

the requirements of the crystal or resonator (see Figure 14). CL1 and CL2 are usually the

same size. The crystal manufacturer typically specifies a load capacitance which is the

series combination of CL1 and CL2. PCB and MCU pin capacitance must be included (10 pF

can be used as a rough estimate of the combined pin and board capacitance) when sizing

CL1 and CL2.

For information on electing the crystal, refer to the application note AN2867 “Oscillator

design guide for ST microcontrollers” available from the ST website www.st.com.

Figure 14. Typical application with an 8 MHz crystal

Resonator with

integrated capacitors

CL1

8 MH z

resonator

CL2

REXT(1)

OSC_IN

RF

OSC_OU T

Bias

controlled

gain

1. REXT value depends on the crystal characteristics.

fHS E

MS19876V1

DocID022691 Rev 4

75/131

114

Share Link: