DSPIC33FJ32GP802-I/SP View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
DSPIC33FJ32GP802-I/SP Datasheet PDF : 402 Pages
| |||
dsPIC33FJ32GP302/304, dsPIC33FJ64GPX02/X04, AND dsPIC33FJ128GPX02/X04
15.1 Output Compare Modes
Configure the Output Compare modes by setting the
appropriate Output Compare Mode (OCM<2:0>) bits in
the Output Compare Control (OCxCON<2:0>) register.
Table 15-1 lists the different bit settings for the Output
Compare modes. Figure 15-2 illustrates the output
compare operation for various modes. The user appli-
cation must disable the associated timer when writing
to the output compare control registers to avoid mal-
functions.
Note 1: Only OC1 and OC2 can trigger a DMA
data transfer.
2: See Section 13. “Output Compare” in
the “dsPIC33F/PIC24H Family Reference
Manual” (DS70209) for OCxR and
OCxRS register restrictions.
TABLE 15-1: OUTPUT COMPARE MODES
OCM<2:0>
Mode
OCx Pin Initial State
000 Module Disabled
Controlled by GPIO register
001 Active-Low One-Shot
0
010 Active-High One-Shot
1
011 Toggle Mode
Current output is maintained
100 Delayed One-Shot
0
101 Continuous Pulse mode
0
110 PWM mode without fault
protection
0, if OCxR is zero
1, if OCxR is non-zero
111 PWM mode with fault protection 0, if OCxR is zero
1, if OCxR is non-zero
OCx Interrupt Generation
—
OCx Rising edge
OCx Falling edge
OCx Rising and Falling edge
OCx Falling edge
OCx Falling edge
No interrupt
OCFA Falling edge for OC1 to OC4
FIGURE 15-2:
OUTPUT COMPARE OPERATION
Output Compare
Mode enabled
Timer is reset on
period match
OCxRS
TMRy
OCxR
Active-Low One-Shot
(OCM = 001)
Active-High One-Shot
(OCM = 010)
Toggle Mode
(OCM = 011)
Delayed One-Shot
(OCM = 100)
Continuous Pulse Mode
(OCM = 101)
PWM Mode
(OCM = 110 or 111)
DS70292D-page 198
Preliminary
2009 Microchip Technology Inc.
Share Link: 